This paper presents the conceptual stages of the simulation and development of a modified transceiver antenna for a high-power pulsed nuclear quadrupole resonance (NQR) detector of explosives containing the 14N isotope. At a frequency of 4.645 MHz, better characteristics are obtained using a nine-turn coil shaped as half of a Fermat spiral with an outer radius of 75 mm. Using a COMSOL Multiphysics numerical parametric simulation and a materials browser, it was possible to calculate a physical system with parameters as close to reality as possible. According to the results of the experimental studies of the radio frequency (RF) energy, the proposed antenna features an increase in the working area compared to a similar antenna, the topology of the conductive coil of which has the form of an Archimedean spiral. The resulting diagrams of the distribution of the magnetic induction also indicate that the topology of the electromagnetic (EM) field does not depend on the orientation of the sample under study relative to the axis of the radial symmetry observed in square–rectangular planar antennas.

Direction of arrival (DoA) estimation is of primary importance in a broad range of wireless applications, where electromagnetic waves play a role. While a vast majority of existing techniques is based on phase lag comparison in antenna arrays, intensity-based approaches are valuable in a range of low budget applications. Here we demonstrate a direct visible to a naked eye DoA device, based on a Fresnel zone plate lens, aperture, and a light-emitting diode indicator. Being a low budget device, it still allows achieving up to 90° angle of view, 19° of angular resolution, and 11° of angular accuracy at 10 GHz operational frequency. The demonstrated approach provides fast DoA visualization and can be used to adjust point-to-point communication links, identify radio wave pollution sources at home conditions and several others.

No abstract

The paper is devoted to the investigation of radiation frequencies characteristics of a modified waveguide aperture by wire media (WM). Such construction allows radiating weak electromagnetic (EM) waves-their frequencies are non-corresponding to the resonant ones of the modified radiator. It is possible due to the unusual properties of metamaterials, namely the negative value of permittivity of WM. The study of the simulation shows that the changing of value of wires radius and at the same time the value of filling factor impacts on the radiation frequency. Therefore, the increase of the filling factor leads to the increase of the resonance frequency. The radiation is narrowband with S 11-parameter less than −20 dB. The experimental investigation shows that the decrease of the value of lattice period allows increase of the width of radiation frequency range from 30-40 MHz up to approximately 80 MHz at the level of 0.3 (≈ −10 dB). At the same time, the increase of wires' radius values leads to the increase of the value of resonant frequency. Finally, the experimental study demonstrates that the value of overlap between waveguide port (source of EM waves) and WM sample negligibly impacts on the resonance frequency values and operational range for D/L = 0...0.3.

No abstract