Knowledge of the material properties of the periodontal ligament is fundamental to an understanding of orthodontic tooth movement and thus to selection of an optimal force system for orthodontic treatment.
The experimental results allow characterization of the tissue and thus contribute to an understanding of the biomechanics of tooth displacement under externally applied loads.
The aim of the present study was to investigate experimentally the mechanical properties of tooth deflection under external loading. These properties have a significant impact on tooth movement during orthodontic treatment. The stresses and strains caused by tooth movement influence bone remodelling, which is the basis of orthodontic treatment. The movement of a tooth as a direct reaction to the forces acting on it is termed "initial" movement. It is nonlinear and has a clearly time-dependent component. While the initial tooth movement represents the totality of the reaction mechanisms of all the tissues of the tooth unit, it is determined primarily by the mechanical properties of the periodontal ligament (PDL). The PDL is the softest tissue of the tooth unit and is therefore subject to the largest deformations when forces act on the crown of the tooth. The objective of orthodontic treatment is to achieve as precise and rapid tooth movement as possible, without provoking such undesired effects as bone and root resorption. To enable the implementation of an optimal orthodontic force system that meets these requirements, a thorough knowledge of the biomechanics of tooth movement is a must.
The periodontal ligament is a tissue that attaches the tooth (root) to its alveolar socket, and thus plays an important role in the regulation of tooth movements. Detailed knowledge of the material properties of the periodontal ligament is therefore essential to an understanding of tooth reaction to forces applied during orthodontic treatment. A knowledge of material parameters can also be used in simulations of long-term tooth movements with the aim of improving orthodontic treatment. To this end, this study investigated time-dependent material properties, namely the hysteresis behaviour of the periodontal ligament under constant-velocity loading, the influence of loading velocity on the hysteresis, and its failure under constant loading. Specimens obtained from pigs were used for testing purposes, and the experiments were conducted in a special test setup using a material testing device. The material behaviour of the periodontal ligament was shown to be viscoelastic, and the elastic parameters of material behaviour were also determined. Under constant-velocity loading, material behaviour showed a nonlinear course of the stress-strain curve, also known as hysteresis. When loading was repeated several times, the maximum stress of the hysteresis decreased with each cycle. Determination of the deflection of the specimen at different velocities showed maximum stress to be dependent on the loading rate. The measured stress-strain curves were approximated by bilinear behaviour, permitting the use of finite element calculations. Also investigated was the failure behaviour of the periodontal ligament, which revealed tissue rupture to be inconstant.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.