Radome is an aerodynamic structural part attached to the fore‐end of a missile. It transmits electromagnetic signals with minimum attenuation and also protects radar communication system, and thus, the radomes are made of ceramics as they have desirable properties required by the radomes. The flexural strength, dielectric constant, and loss tangent values of various ceramic materials used in the development of radomes are important in the selection of radome materials. Different nose cone shapes of missile radomes are also important. Ceramic materials show variational properties with sintering time, temperature, and other additives. The existing different near‐net shape fabrication techniques for manufacturing of ceramic radomes are discussed and compared. Gelcasting is one of the manufacturing techniques to produce radomes with homogeneous and high green strength. Gelcast parts of silicon nitride ceramics are hard, tough, brittle, and wear‐resistant and are difficult to machine using conventional methods of machining. Therefore, laser‐assisted machining is used for fine finish of ceramic radomes with excellent surface integrity and productivity. This paper deals with a review of development of ceramic radomes, manufacturing methods for variety of applications.

No abstract

In this work, a novel method for the preparation of colloids has been studied for the fabrication of silicon nitride –Boron nitride composites. In the present work, the dispersion of mixed silicon nitride –Boron nitride powders in aqueous media was studied with the changes dispersant concentration, solution pH etc. Polyethylenimine (PEI) additive as a dispersant were used for Si3N4 and BN powders in aqueous media. Well-dispersed Si3N4 and BN powders in aqueous media were attained atthe 1 wt% PEI and pH 9. 40 vol% covered Si3N4/BN slurries with varying BN content was adapted for gel casting. The gel casted material waspreheated at normal room temperature, debindered at 6000C and sintered at 17000C. The sintered composite material composed mainly of alpha-Si3N4, beta-Si3N4, and h-BN. The prepared composite material shows uniform microstructure with faceted particles, α-Si3N4 and abundant pores.

No abstract

No abstract