The number of cotton plants grown per unit of ground area has gained attention due to the high prices of inputs and lower production. Cotton yield per unit of area in Henan province has been stagnant in the last few years. The objectives of this study were to investigate cotton growth, yield, boll spatial distribution and biomass accumulation using different plant densities at cultivation and to find out the optimal plant density. A 2-year field experiment was conducted in a randomized complete block design under six plant densities (D1, 15,000; D2, 33,000; D3, 51,000; D4, 69,000; D5, 87,000 and D6, 105,000 ha−1). Cotton grown at lower plant density produced taller plants and high number of leaves per plant while greater number of branches, fruiting nodes and high number of bolls per unit of ground area were produced under high plant density. Boll retention rate decreased as plant population increased and at nodes 1–8 the rate decreased slowly and then increased dramatically. The highest seed cotton yield (4546 kg ha−1) and lint yield (1682 kg ha−1) was produced by D5. The seed cotton and lint yield produced by D5 were 51–55%, 40–37%, 22–26%, 11–15%, 12–15%, 28–30%, 21–24%, 15–20%, 7–13% and 13–17% higher than D1, D2, D3, D4 and D6 during both years of experimentation, respectively. The increase in seed yield was due to higher biomass accumulation in reproductive organs under D5 plant density. The highest average (110.4 VA kg ha−1 d−1) and maximum (126 VM kg ha−1 d−1) rate of reproductive organs biomass was also accumulated by D5 as compared to other plant densities. The results suggest that D5 is the optimal plant density for high reproductive biomass accumulation and high yield for the area of Henan province.

Continuous cropping of rice (Oryza sativa L.) and wheat (Triticum aestivum L.) deplete soil fertility and reduce crop productivity as well as zinc (Zn) concentrations in rice grains and straw. Low Zn concentrations in rice grains have a negative impact on human health, while low Zn concertation in rice straw creates a nutritional problem for animals. The current high yielding rice varieties and hybrids remove large quantities of Zn from the soils, lowering the residual concentrations of soil Zn for the subsequent crop (e.g., wheat). Field experiments were conducted on farmers field in Malakand with the objective to evaluate the impact of various combinations of phosphorus (0, 40, 80, and 120 kg ha−1) and Zn levels (0, 5, 10, and 15 kg ha−1) on biofortification of Zn in grains and straw of rice genotypes [fine (Bamati-385) vs. coarse (Fakhre-e-Malakand and Pukhraj)]. The results revealed that Zn biofortification in rice genotypes increased with the integrated use of both nutrients (P + Zn) when applied at higher rates (80 and 120 kg P ha−1, and 10 and 15 kg Zn ha−1, respectively). The biofortification of Zn in both grains and straw was higher in the coarse than fine rice genotypes (Pukhraj > Fakhre-e-Malakand > Basmati-385). It was concluded from this study that the application of higher P and Zn levels increased Zn contents in rice parts (grains and straw) under the rice-wheat system. We also concluded from this study that Zn concentrations in rice grains and straw are influenced by plant genetic factors and Zn management practices.

The number of cotton plants grown per unit area has recently gained attention due to technology expense, high input, and seed cost. Yield consistency across a series of plant populations is an attractive cost-saving option. Field experiments were conducted to compare biomass accumulation, fiber quality, leaf area index, yield and yield components of cotton planted at various densities (D1, 1.5; D2, 3.3; D3, 5.1; D4, 6.9; D5, 8.7; and D6, 10.5 plants m−2). High planting density (D5) produced 21% and 28% more lint yield as compared to low planting density (D1) during both years, respectively. The highest seed cotton yield (4662 kg/ha) and lint yield (1763 kg/ha) were produced by high plant density (D5) while the further increase in the plant population (D6) decreased the yield. The increase in yield of D5 was due to more biomass accumulation in reproductive organs as compared to other treatments. The highest average (19.2 VA gm m−2 d−1) and maximum (21.8 VM gm m−2 d−1) rates of biomass were accumulated in reproductive structures. High boll load per leaf area and leaf area index were observed in high planting density as compared to low, while high dry matter partitioning was recorded in the lowest planting density as compared to other treatments. Plants with low density had 5% greater fiber length as compared to the highest plant density, while the fiber strength and micronaire value were 10% and 15% greater than the lowest plant density. Conclusively, plant density of 8.7 plants m−2 is a promising option for enhanced yield, biomass, and uniform fiber quality of cotton.