No abstract

Abstract. Snow algal bloom is a common phenomenon on melting snowpacks in polar and alpine regions and can substantially increase snow melt rates due to the effect of albedo reduction on the snow surface. In order to reproduce algal growth on the snow surface using a numerical model, temporal changes in snow algal abundance were investigated on the Qaanaaq Glacier in north-western Greenland from June to August 2014. Snow algae first appeared at the study sites in late June, which was approximately 94 h after air temperatures exceeded the melting point. Algal abundance increased exponentially after this appearance, but the increasing rate became slow after late July, and finally reached 3.5 × 10 7 cells m −2 in early August. We applied a logistic model to the algal growth curve and found that the algae could be reproduced with an initial cell concentration of 6.9 × 10 2 cells m −2 , a growth rate of 0.42 d −1 , and a carrying capacity of 3.5 × 10 7 cells m −2 on this glacier. This model has the potential to simulate algal blooms from meteorological data sets and to evaluate their impact on the melting of seasonal snowpacks and glaciers.

Cryoconite granules are aggregations of microorganisms with mineral particles that form on glacier surfaces. To understand the processes by which the granules develop, this study focused on the altitudinal distribution of the granules and photosynthetic microorganisms on the glacier, bacterial community variation with granules size and environmental factors affecting the growth of the granules. Size-sorted cryoconite granules collected from five different sites on Qaanaaq Glacier were analyzed. C and N contents were significantly higher in large (diameter greater than 250 μm) granules than in smaller (diameter 30-249 μm) granules. Bacterial community structures, based on 16S rRNA gene amplicon sequencing, were different between the smaller and larger granules. The filamentous cyanobacterium Phormidesmis priestleyi was the dominant bacterial species in larger granules. Multivariate analysis suggests that the abundance of mineral particles on the glacier surface is the main factor controlling growth of these cyanobacteria. These results show that the supply of mineral particles on the glacier enhances granule development, that P. priestleyi is likely the key species for primary production and the formation of the granules and that the bacterial community in the granules changes over the course of the granule development.

Cryoconite holes are water-filled cylindrical holes formed on ablation ice surfaces and commonly observed on glaciers worldwide. Temporal changes of cryoconite holes characteristically <5 cm in diameter were monitored with a time-lapse interval camera over 15 d during the melting season on Qaanaaq Glacier in northwest Greenland. The holes drastically changed their dimensions and synchronously collapsed twice during the study period. When the holes collapsed, the coverage of cryoconite on the ice surface increased from 1.0 to 3.5% in the field of view of the camera, and then decreased again to 0.4% after the holes reformed. Comparison with meteorological data showed that the collapses occurred in cloudy and rainy or windy weather conditions, corresponding to low shortwave solar radiation (68–126 W m−2, 40–55% of the incoming flux). In contrast, holes developed in sunny conditions correspond to high solar radiation (186–278 W m−2, 63–88%). Results suggest that the dimensions of holes drastically changed depending on the weather conditions and that frequent cloudy, warm and windy conditions would cause a decay of holes and weathering crust, inducing an increase in the cryoconite coverage on the ice, consequently darkening the glacier surface.

) on snow surface at the study sites. On Qaanaaq Glacier (an outlet glacier of Qaanaaq Ice Cap) impurity abundance was greatest at mid-elevations, with fewer impurities at upper and lower sites. Surface reflectivity was lowest in the mid-elevation area, suggesting that impurities substantially reduce ice surface albedo at mid-elevations on glacier surfaces. Organic matter content in the impurities ranged from 1.4 to 12.0% (mean: 5.4%) on the ice and from 3.2 to 10.6% (mean: 6.7%) on the snow surface. Microscopy revealed that impurities in the ice areas mainly consisted of cryoconite granules, which are aggregations of mineral particles, filamentous cyanobacteria and other microbes and organic matter, while those in snow areas consisted of mineral particles and snow algae. Results suggest that the spatial variation in the abundance of impurities is caused by supply of mineral particles both from air and ice, and microbial production of organic matter on the glacier surface.