Magnetite nanoparticles were prepared by hydrothermal synthesis under various initial ferrous/ferric molar ratios without adding any oxidizing and reducing agents in order to clarify effects of the molar ratio on the reaction mechanism for the formation of magnetite nanoparticles. The magnetite nanoparticles prepared were characterized by a scanning electron microscope, powder X-ray diffractometer, and superconducting quantum interference device (SQUID). At the molar ratio corresponding to the stoichiometric ratio in the synthesis reaction of magnetite from ferrous hydroxide and goethite, the nucleation of magnetite crystals progressed rapidly in an initial stage of the hydrothermal synthesis, resulting in formation of the magnetite nanoparticles having a smaller size and a lower crystallinity. On the other hand, at higher molar ratios, the particle size and crystallinity increased with increasing molar ratio because using surplus ferrous hydroxide the crystallites of magnetite nanoparticles grew up slowly under hydrothermal conditions according to the Schikorr reaction. The magnetite nanoparticles prepared under various molar ratios had good magnetic properties regardless of the molar ratio.

This study provides a facile single-step coprecipitation method for preparing size-controlled high crystalline magnetite nanoparticles in water system without using any organic solvents. In this method, an iron ions solution and an alkaline solution are simply mixed at room temperature without using any additional heating treatment. The size of obtained magnetite nanoparticles greatly depended on the coexisting anionic species in the starting solution because the coexisting anions greatly influenced both the formation of crystal nuclei and the dispersion stabilisation of formed precipitates. The size control of magnetite nanoparticles having high crystallinity and ferromagnetic property could be successfully achieved by using the effects of coexisting anions. For synthesising finer magnetite nanoparticles, the presence of lactate ion in the starting solution was effective, and coarser ones could be synthesised under higher ferrous/ferric ions molar ratios.

No abstract

A novel method for preparing fine magnetite nanoparticles without using any additives and organic solvents has been developed. In this method, a sequential precipitates formation method, ferrous and ferric hydroxides are not coprecipitated but sequentially formed in an alkaline solution, and then the resulting suspension is subjected to a hydrothermal treatment. The obtained magnetite nanoparticles were characterised through scanning electron microscopy observation and X-ray diffraction analysis, and the particle size and magnetic properties were measured with a dynamic light scattering particle size analyser and a superconducting quantum interference device magnetometer, respectively. In order to prepare fine magnetite nanoparticles with a uniform size, both the formation sequence of ferrous and ferric hydroxide precipitates and the supersaturation of ferric hydroxide in the solution were essential. The ferromagnetic magnetite nanoparticles with a median size 8.5 nm were relatively easily obtained in the formation process in which a ferric sulphate solution was rapidly poured into a suspension of ferrous hydroxide particles prepared beforehand using ferric chloride and sodium hydroxide, whereas the median size of magnetite nanoparticles prepared via conventional coprecipitation route was 38.6 nm.

No abstract