Abstract:In the present study, the flow structure of discontinuous double-layered vegetation patches was investigated using a 3D Reynolds stress turbulence model (RSM). The channel domain was built using GAMBIT (Geometry and Mesh Building Intelligent Toolkit). For the simulation and postprocessing, FLUENT (ANSYS) was used to analyze the distribution of the mean velocity, Reynolds stresses, and other flow properties against two different flow conditions. The results captured by the turbulence model at specific locations and the cross section are presented in the form of various velocity profiles and contour plots. In the gap portion, the velocity was visibly lower than that in the vegetation areas, while the influence of patch distribution was not visible in the overlying flow layer. The velocity profiles at critical locations were categorized by numerous modulation points and velocity projections close to the bed, principally for positions straight after the vegetation structures. A distinction in the velocity at the topmost of the smaller vegetation structure was prominent. Reynolds stresses, turbulent kinetic energy, and turbulence intensity exhibited large fluctuations inside the vegetation regions and just behind the vegetation structures compared with in the gap regions.

No abstract

Riparian vegetation does not only affect the channel flow carrying capacity, but also plays significant roles in water management, stream restoration, and river rehabilitation. This study numerically investigates the flow characteristics through longitudinally discontinuous rigid vegetation occupying half width of the channel, with the help of three-dimensional software FLUENT in which a Reynolds stress turbulence model was adopted. Three varying conditions of vegetation were considered comprising of vertically double-layered vegetation (DLV), submerged vegetation (SV), and emergent vegetation (EV) while keeping the same vegetation density, as well as a varying discharge condition against DLV was also tested. The results indicated that the flow distribution becomes more complex through DLV and SV followed by multiple layers with an inflectional instability in the vertical velocity profile around submerged canopy top, as compared to the flow through EV where the uniform distribution of flow over the canopy column was observed. The velocity in the canopy zone decreased considerably because of the resistance due to vegetation, which influenced the channel carrying capacity, in comparison to that in the non-vegetated zone. The flow velocities through the obstructed part of the channel, that is, canopy zone, in DLV arrangement reduced by a percentage difference of approximately 42 and 37% compared to that of SV and EV arrangements, respectively; whereas it was reduced by approximately 55% when the discharge was twice while keeping the same configuration of DLV. The inflectional instabilities and estimated mixing layer over the interfacial zone suggested a stronger lateral exchange of momentum for DLV configuration in comparison to that of SV and EV. Within the gaps between the patch zones, the flow velocity, turbulent kinetic energy, and turbulent intensity reduced significantly due to blockage effect and sheltering offered by the vegetation patches, signifying a positive flow response towards aquatic life and sediment deposition.

No abstract

The aim of this paper is to numerically investigate how the flow structures are affected through a longitudinally discontinuous and vertically two‐layered vegetation occupying half width of the channel, with steady flow rate and subcritical conditions. A three‐dimensional (3‐D) Reynolds stress turbulence model (RSM), incorporated by Computational Fluid Dynamics (CFD) code FLUENT, was first validated with the experimental data, and then used for simulation purpose. The results showed that the flow stream‐wise velocities within the gap regions are visibly slower than that in the vegetation patch regions. Along the cross section, the velocity in the vegetation region (VR) reduced significantly due to resistance offered by the vegetation, which affected the channel conveyance; as compared to the free (non‐vegetated) region. The flow instability in the lateral direction was triggered by the flow shear due to the presence of partly distributed vegetation, resulting in the formation of coherent vortices and exchange of momentum at the interface. The discharge percentage passing through the free region (FR) was found to be 144–525% larger than that passing through the VR. The flow resistance increased significantly with higher vegetation density, whereas it decreased when both the vegetation layers were submerged. Moreover, the flow characteristics profiles in large gaps were more stable than in small gaps. The turbulent kinetic energy (TKE) and turbulence intensity also increased significantly through the patch regions compared to that of the gap regions. The results indicated that the flow structures and the flow resistance are strongly influenced by partial and discontinuous vegetation.