No abstract

No abstract

The purpose of this study was to introduce antibacterial property to pits and fissure sealant (PFS) in order to mitigate the major clinical problems associated with PFS, such as microleakage and secondary caries. We prepared a pH reliant cobalt oxide nanoparticle incorporated with minocycline (MNC@CO) and characterized to investigate its antibacterial potential against Streptococcus sobrinus. The physiochemical, morphological, and drug release kinetics at different pH (7.4, 5.0, and 3.5) from nanoparticles were investigated. The MNC@CO were added at 2.5% and 5.0% into experimental PFS and characterized for their antibiofilm capacity, biocompatibility, and mechanical properties including compressive and flexural strength. The groups 2.5% and 5.0% has shown statistically significant antimicrobial capacity against S. sobrinus compared to control (p < .05). The highest percentage of MNC release at different pH (especially at pH 5.0 and 3.5) was observed from 5.0% MNC@CO doped PFS. The PFS doped with 2.5% MNC@CO showed a highest compressive strength (110 MPa) over a period of 70 days as compared to 5.0% MNC@CO (75 MPa) and control (80 MPa). The flexural strength of both experimental groups was lower for both time points (24 h and 30 days) than control. In conclusion, the present study found that 2.5% MNC@CO doped PFS showed considerable anti-biofilm potential without compromising mechanical properties.

No abstract

The research aimed to determine the tensile bond strength (TBS) between polymerized intact and ground fiber-reinforced composite (FRC) surfaces. FRC prepregs (a reinforcing fiber pre-impregnated with a semi-interpenetrating polymer network (semi-IPN) resin system; everStick C&B) were divided into two groups: intact FRCs (with a highly PMMA-enriched surface) and ground FRCs (with a low PMMA gradient). Each FRC group was treated with: StickRESIN and G-Multi PRIMER. These groups were further divided into four subgroups based on the application time of the treatment agents: 0.5, 1, 2, and 5 min. Next, a resin luting cement was applied to the FRC substrates on the top of the photo-polymerized treating agent. Thereafter, weight loss, surface microhardness, and TBS were evaluated. Three-factor analysis of variance (p ≤ 0.05) revealed significant differences in the TBS among the FRC groups. The highest TBS was recorded for the intact FRC surface treated with G-Multi PRIMER for 2 min (13.0 ± 1.2 MPa). The monomers and solvents of G-Multi PRIMER showed a time-dependent relationship between treatment time and TBS. They could diffuse into the FRC surface that has a higher PMMA gradient, further resulting in a high TBS between the FRC and resin luting cement.