No abstract

In this investigation, chemical characteristics, higher, lower and net heating value, bulk and energy density, and thermogravimetric analysis were applied to study the thermal characteristics of three algal biomasses. These biomasses, grown as by-products of wastewater treatment in high-rate algal ponds (HRAPs), were: (i) biomass produced in domestic effluent and collected directly from an HRAP (PO); (ii) biomass produced in domestic effluent in a mixed pond-panel system and collected from the panels (PA); and (iii) biomass originating from the treatment effluent from the meat processing industry and collected directly from an HRAP (IN). The biomass IN was the best alternative for thermal power generation. Subsequently, a mixture of the algal biomasses and Jatropha epicarp was used to produce briquettes containing 0%, 25%, 50%, 75%, and 100% of algal biomass, and their properties were evaluated. In general, the addition of algal biomass to briquettes decreased both the hygroscopicity and fixed carbon content and increased the bulk density, ash content, and energy density. A 50% proportion of biomass IN was found to be the best raw material for producing briquettes. Therefore, the production of briquettes consisting of algal biomass and Jatropha epicarp at a laboratory scale was shown to be technically feasible.

This study investigated an industrial biosludge drying system using hot gases from a coal furnace, seeking to increase the solids content of the biosludge above 50% (w.b.), considered suitable for combustion in biomass boilers. Biosludge was collected from a paper mill activated sludge plant. Biosludge mixtures with eucalyptus chips and eucalyptus bark in two different proportions (15% and 25%) were placed into a drying chamber. Hot gases generated by the furnace, with a flowrate of 0.64 ± 0.02 m s at 100 ± 20°C, were applied to the piles through a blowing system. The results demonstrated that the 75% biosludge/25% eucalyptus bark mixture achieved the best drying ratio, increasing the total solids content from 31% to 72%, over a 5-h drying period. Nevertheless, all other treatments involving the addition of a bulking agent achieved solids content above 50%, confirming the positive effect of adding dried material to the sludge. These results indicate a potential use of hot gases that are currently available and released into the atmosphere by paper mills.

Considerable increases in industrial and urban wastewater sludge generation in recent years require proper treatment, such as thermal drying, and disposal. The sludge drying is a complex process involving simultaneous and coupled heat and mass transfer, which can be modeled by taking into account mass and heat balances, and assuming that water diffuses according to kinetic laws. This research implemented a simulation model for biosludge drying processes to predict the temperature and moisture distribution inside the biosludge, using the COMSOL Multiphysics® simulation program v5.2. A parametric analysis was carried out to determine the effect of initial moisture content on biosludge final temperature and moisture reduction. The simulated temperature and moisture content were experimentally validated and good agreement was observed between the simulation and experimental results. This model is a useful tool to optimize the drying process and develop better strategies for the control of the system.