No abstract

Heavy metals, known for their toxic nature and ability to accumulate and magnify in the food chain, are a major environmental concern. The use of environmentally friendly adsorbents, such as chitosan (CS)—a biodegradable cationic polysaccharide, has gained attention for removing heavy metals from water. This review discusses the physicochemical properties of CS and its composites and nanocomposites and their potential application in wastewater treatment.

This study was conducted to investigate the effect of different in-house practices on trihalomethane (THM) level fluctuations in pipe-borne water. Common in-house practices such as boiling, unboiling, boiling water with headspace/non-headspace, storage vessels materials, storage practices, and storage time were investigated to study residual THM and their percentage. Vessels made of plastic (P), clay (C), stainless steel (SS), glass (G), and aluminium (Al) were used for the study. Prime trihalomethanes of CHCl3, CHBrCl2, CHBr2Cl, CHBr3, and total of those four THMs (TTHMs) were measured, and removal/formation percentages were calculated. Results revealed that the percent change of TTHM varies based on the boiling practice as follows: open boiling TTHM > close boiling with headspace TTHM > close boiling without headspace (CBWH) TTHM. The following order was observed for residual TTHM for 6 h storage in the vessels; for CBWH water storage in open vessels C < G < P < SS < Al and close vessels C < G < P < SS < Al; and for un-boiled water storage in open vessels SS < C < Al < P < G and close vessels C < P < Al < SS < G. In conclusion, the lowest concentration of residual TTHM was found in the boiled water stored in a clay pot and recommended as an in-house practice to reduce TTHM.