The parameters of electrical network modes do not correspond the requirements GOST 32144-2013 of Russian and the National technical regulation of Vietnam. In real operating conditions in electrical networks in non-sinusoidal and unbalanced modes there are harmonic components of voltages and currents as well as voltages and currents of negative sequence. They cause additional losses of active power, which leads to additional heating and causes premature aging of the insulation, and as the result, the reduction in the service life of induction motors. Currently, we see that the process of formation of intelligent electrical power systems is underway. Systems for continuous monitoring of power quality indices and parameters of electrical systems modes are being developed. These systems can be supplemented with programs for calculating characteristics that issue the warning when the unfavorable influence of the parameters of non-sinusoidal and unbalanced modes is detected on various electrical equipment of both electrical power systems and consumers of electrical energy. The paper provides an overview of the characteristics used to analyze, assess and predict the influence of poor power quality associated with non-sinusoidal and unbalanced of currents and voltages on induction motors. A computer program was developed to calculate these characteristics. The program was used to study the influence of non-sinusoidal and unbalanced modes on the induction motors of the coal sorting plant of the Vietnamese company “Cua Ong-Vinacomin”.

No abstract

The parameters of electrical network modes often do not meet the requirements of Russian GOST 32144-2013 and the guidelines of Vietnam. In the actual operating conditions while there is the non-sinusoidal mode in electrical networks voltage and current harmonics are present. Harmonics result in overheating and damage of power transformers since they cause additional active power losses. Additional losses lead to the additional heat release, accelerating the process of insulating paper, transformer oil and magnetic structure deterioration consequently shortening the service life of a power transformer. In this regard there arises a need to develop certain scientific methods that would help demonstrate that low power quality, for instance could lead to a decrease in the electrical equipment service life. Currently we see a development of automated systems for continuous monitoring of power quality indices and mode parameters of electrical networks. These systems could be supplemented by characteristics calculating programs that give out a warning upon detection of the adverse influence of voltage and current harmonics on various electrical equipment of both electric power providers and electric power consumers. A software program presented in the article may be used to predict the influence of voltage and current harmonics on power transformers.

The electrical equipment operation is cost-effective and reliable when operating parameters of the electrical network correspond to the rated data of the equipment. The real operation conditions, however, differ from those required for electrical equipment, which negatively affects its efficiency. The non-sinusoidal conditions in electrical networks are currently very common. The paper provides an overview of the characteristics obtained from an analysis of publications, which are used to evaluate the effect of the non-sinusoidal conditions on power transformers. The results of the calculation of these characteristics for a transformer installed at a railway traction substation are presented. Parameters of the non-sinusoidal conditions are obtained as a result of measurements.