Due to increase in integration of renewable energy into the grid and power quality issues arising from it, there is need for analysis and power improvement of such networks. This paper presents voltage profile, Q-V sensitivity analysis and Q-V curves analysis for a grid that is highly penetrated by renewable energy sources; solar PV, wind power and small hydro systems. Analysis is done on IEEE 39 bus test system with Wind power injection alone, PV power injection alone, with PV and wind power injection and with PV, wind and micro hydro power injection to the grid. The analysis is used to determine the buses where voltage stability improvement is needed. From the results, it was concluded that injection of the modeled wind power alone helped in stabilizing the voltage levels as determined from voltage profiles and reactive power margins. Replacing some of the conventional sources with PV power led to reduction of voltages for weak buses below the required standards. Injection of power from more than one renewable energy source helped in slightly improving the voltage levels. Distribution Static compensators (D-STATCOMs) were used to improve the voltage levels of the buses that were below the required standards.

Wind power penetration into the grid is increasing throughout the world due to centralized power generation constraints such as shortage of fossil fuel, need to reduce gas emissions, long transmission losses and need for more supply of electrical power. Connection of wind power into the grid results in power quality issues such as voltage profile changes and harmonics. This necessitates coming up with correction measures in order to meet power quality standards. This paper deals with the analysis of the effects of injecting wind power to the grid on voltage profile. Branch participation factors are used to analyze the sections of the grid where effects on voltage profile are highest due to wind power penetration. Reactive power-voltage sensitivity analysis is used to determine the buses that are more sensitive to the changes brought by the wind power injection. Two cases were considered for the injection of the wind power: IEEE 14 test bus system and IEEE 39 test bus system.

No abstract