A method to calculate the ultimate intrinsic signal-to-noise ratio (SNR) in a magnetic resonance experiment for a point inside an arbitrarily shaped object is presented. The ultimate intrinsic SNR is determined by body noise. A solution is obtained by optimizing the electromagnetic field to minimize total power deposition while maintaining a constant right-hand circularly polarized component of the magnetic field at the point of interest. A numerical approximation for the optimal field is found by assuming a superposition of a large number of plane waves. This simulation allowed estimation of the ultimate intrinsic SNR attainable in a human torso model. The performance of six coil configurations was evaluated by comparing the SNR of images obtained by the coils with the ultimate values. In addition, the behavior of ultimate intrinsic SNR was investigated as a function of main field strength. It was found that the ultimate intrinsic SNR increases better than linearly with the main magnetic field up to 10 T for our model. It was observed that for field strengths of 4 T or higher, focusing is required to reach the ultimate intrinsic SNR.

Recently, intravascular catheter probes have been developed to increase signal-to-noise ratio (SNR) for MR imaging of blood vessels. Miniaturization of these catheter probes without degrading their performances is very critical in imaging small vessels such as coronary arteries. Catheter coils have a loop incorporated in their structure and have limitations in physical dimensions and electromagnetic properties. The use of a loopless intravascular catheter antenna is proposed to overcome these problems. The catheter antenna is essentially a dipole, which makes a very thin diameter possible, and its electronic circuitry can be placed outside the blood vessels without performance degradation. The theoretical foundation for the design and operation of the catheter antenna is presented. Several catheter antennae, as small as 1.5 French, were constructed and tested on phantoms and rabbits with great success. The catheter antenna has a simple structure and is easy to design, implement, and operate.

Potentially important diagnostic information about atherosclerosis can be obtained by using magnetic resonance imaging and spectroscopy techniques. Because critical vessels such as the aorta, coronary arteries, and renal arteries are not near the surface of the body, surface coils are not adequate to increase the data quality to desired levels. A few catheter MR receiver coil designs have been proposed for imaging the walls of large blood vessels such as the aorta. These coils have limited longitudinal coverage and they are too thick to be placed into small vessels. A flexible, long and narrow receiver coil that can be placed on the tip of a catheter and will enable multi-slice high resolution imaging of small vessels has been developed. The authors describe the theory of the coil design technique, derive formulae for the signal-to-noise ratio characteristics of the coil, and show examples of high resolution cross-sectional images from isolated human aortas acquired by using this catheter coil. In addition, high resolution in vivo rabbit aorta images were obtained as well as a set of spatially resolved chemical shift spectra from a dog circumflex coronary artery.