No abstract

The reaction of titanium (IV) chloride and amines in an atmospheric pressure chemical vapor deposition (APCVD) has been previously shown to produce high quality titanium nitride films. These films were gold in appearance with high infrared reflectivity and resistivities as low as 80 microhm-cm. In the present study, the carbon content of the amines was systematically increased and the carbon levels in the films measured by XPS. For primary amines carbon contamination was not detected. Films deposited from secondary and tertiary amines had measurable carbon contamination. Correlation of carbon contamination with electrical resistivity and infrared reflectivity is discussed. Scanning electron micrographs and x-ray diffraction of the films are presented.

Vanadium oxide thin films were grown on glass substrates by atmospheric pressure chemical vapor deposition (APCVD) from the reaction of vanadium(IV) chloride with isopropanol and t-butanol. Films were deposited in the temperature range 250 to 450°C. The as-deposited films were a dark greenish color consistent with formation of a lower oxide of vanadium. Annealing a film deposited on Corning 7059 glass in air converted the material to a yellow film. X-ray diffraction of the yellow film revealed the presence of V2O5. Optical spectra of the films are presented. Glass substrates previously coated with conductive fluorine doped tin oxide were coated with V2O5 and evaluated for electrochromic activity.

No abstract

Atmospheric Pressure Chemical Vapor Deposition (APCVD) and powder spray pyrolysis are both pyrolytic thin film deposition techniques that are used to coat glass with thin films at atmospheric pressure. In the present study, the fluid dynamics of each process was investigated by laser light scattering. For each system, a 193 nm ArF excimer laser pulsed at 7 Hz was used for the analysis. In the case of the APCVD reactor, the difference in Rayleigh scattering between helium injected in the reactor and ambient air was used to characterize the process. For the powder spray process, laser scattering off the sprayed powder was used. The effect of various parameters is discussed.