Autologous bone graftsCurrently, autologous bone grafting is the gold standard for osteogenic bone replacement. This procedure is highly efficient in reconstructing bone defects even under problematic conditions. However, the use of autologous bone grafts is limited by a significant donor site morbidity that increases with the amount of bone harvested [1]. Biomaterials for bone replacement AbstractIntroduction: Biologic bone substitutes may offer alternatives to bone grafting procedures. The aim of this study was to evaluate a preformed bone substitute based on processed bovine cancellous bone (PBCB) with or without osteogenic cells in a critical size calvarial defect rat model. Methods: Discs of PBCB (Tutobone ® ) were seeded with second passage fibrin gel-immobilized syngenic osteoblasts (group A, n = 40). Cell-free matrices (group B, n = 28) and untreated defects (group C; n=28) served as controls. Specimens were explanted between day 0 and 4 months after implantation and were subjected to histological and morphometric evaluation. Results: At 1 month, bone formation was limited to small peripheral areas. At 2 and 4 months, significant bone formation, matrix resorption as well as integration of the implants was evident in groups A and B. In group C no significant regeneration of the defects was observed. Morphometric analysis did not disclose differences in bone formation in matrices from groups A and B. Carboxyfluorescine-Diacetate-Succinimidylester (CFDA) labeling demonstrated low survival rates of transplanted cells. Discussion: Osteoblasts seeded into PBCB matrix display a differentiated phenotype following a 14 days cell culture period. Lack of initial vascularization may explain the absence of added osteogenicity in constructs from group A in comparison to group B. PBCB is well integrated and represents even without osteogenic cells a promising biomaterial for reconstruction of critical size calvarial bone defects.

The aim of this case report is to describe a novel technique for treatment of large osteochondral lesions of the talus using autologous matrix-induced chondrogenesis with a collagen I/III membrane.

IV.

Osteogenic injectable bone substitutes may be useful for many applications. We developed a novel injectable bone substitute based on osteoblast-fibrin glue suspension and calcium phosphate bone cement (BC). Human osteoblasts were isolated from trabecular bone samples and cultured under standard conditions. Osteoblasts were suspended in fibrinogen solution (FS). BC was cured with thrombin solution. 8 × 4 mm injectable bone discs were prepared using silicon molds and a custom-made applicator device. Discs containing BC, BC/FS, or BC/FS/osteoblasts were implanted subcutaneously into athymic nude mice. After 3, 9 and 24 weeks, specimens were explanted and subjected to morphologic and biomechanical evaluation. In vitro fibrin gel-embedded osteoblasts displayed a differentiated phenotype as evidenced by alkaline phosphatase, collagen type 1 and von Kossa stains. A proportion of osteoblasts appeared morphologically intact over a 3-day in vitro period following application into the BC. BC/FS and BC/FS/osteoblast discs were sparsely infiltrated with vascularized connective tissue. There was no bone formation in implants from all groups. However, positive von Kossa staining only in BC/FS/osteoblast groups suggests engraftment of at least some of the transplanted cells. Biomechanical evaluation demonstrated initial stability of the composites. Young’s modulus and maximal load did not differ significantly in the BC/FS and BC/FS/osteoblast groups. The practicability of osteoblast-containing injectable bone could be demonstrated. The dense microstructure and the suboptimal initial vascularization of the composites may explain the lack of bone formation. Modifications with regard to enhanced osteoblast survival are mandatory for a possible application as injectable osteogenic bone replacement system.