Hydrogen embrittlement is one of the most severe steel degradation mechanisms. Using hydrogen enhanced decohesion (HEDE) and hydrogen enhanced local plasticity (HELP), we can predict if more hydrogen atoms will accumulate into the plastic zone, enhancing the hydrogen embrittlement and the crack growth rate. In the current study, a relationship has been proposed between operations of pipeline steels and hydrogen accumulation to quantify the effects of hydrogen embrittlement. The study find that hydrogen accumulation rate is proportional to stress intensity and inversely proportional to temperature; hence, higher stress intensity and lower temperature will enhance hydrogen accumulation and crack propagation. Hydrogen potential, diffusivity, hydrostatic stress near the crack tip, and the critical loading frequency have been considered in the new model to predict crack propagation rates in pipeline steels. The predicted values are compared with experimental results of X-65 steel in two near-neutral pH solutions to verify the model. This hydrogen diffusion model helps show former neglected hazard operations such as minor cycles, and offers an easier way to optimize operations that will prolong the life of pipeline steels.

Crack propagation in near neutral pH (NNpH) environment causes significant threat to pipeline integrity. Internal pressure fluctuations during pipeline operation create variable amplitude loading condition that can propagate corrosion fatigue cracks in NNpH environments. This study is aimed at understanding the effect of load interaction due to mean load pressure fluctuations on crack propagation in pipeline steel under NNpH conditions. The loading condition involved underload followed by an overload at set intervals among minor cycles. The effect of minor cycles, magnitude of overload, and NNpH environment were considered and compared to control test in air. Results showed optimum reduction in crack growth rate at low magnitude of overload in mean load pressure fluctuation. Mini striations observed on fracture surface suggest the contributions of minor cycles to crack propagation due to load interaction. Significant increase in crack growth at high magnitude of overload in NNpH environment indicates the influence of hydrogen.

Pipelines are designed to operate below a maximum operating pressure in service. However, there are pressure fluctuations during operation. The presence of pressure fluctuations creates a drive for crack growth in steel pipes. In order to prevent catastrophic failure of pipelines, there is need for better understanding of the contribution of pressure fluctuations to crack growth rate in steel pipelines. Analysis of pressure fluctuation data in oil and gas pipelines shows that there are different types of fluctuations in a pipe due to friction loss with distance from the pump or compressor station. All these fluctuation types show a form of variable amplitude loading classified in this research as underload, mean load and overload. Studies of some structural systems shows that underload can cause acceleration of crack growth while retardation of crack growth is observed after an overload. This research aims to apply pressure fluctuations to manage integrity of steel pipelines through a novel approach of load sequence involving underload and overload in near neutral pH environment. Clear knowledge of the effect of load interaction involving load sequence of underload and overload is vital to control crack growth in steel pipelines under near neutral pH environment. The result of crack growth rate under different load sequence on X65 steel indicate that increase in overload ratio of 2, 3 and 4 caused an increase in crack growth rate of 1.68E−3, 1.89E−3 and 2.31E−3 mm/block respectively. These results are compared with results from other tests under variable amplitude without load sequence. Analyses were carried out on the morphology of the crack tip and the fracture surface after the test.

Internal pressure fluctuations during pipeline operations could contribute to crack growth in steel pipelines. These pressure fluctuations create a variable amplitude loading condition with large amplitude cycles at near-zero stress ratio, R (minimum stress / maximum stress) and small amplitude cycles (minor cycles) at near +1 R ratio which can both affect crack propagation. Mean stresses fluctuate with pressure due to fluid friction losses proportional to the distance from the pump/compressor station. A deeper understanding of mean stress sensitivity on crack growth rate in steel pipelines is sought. The aim of this research is to retard crack growth in pipelines by prescribing pressure fluctuations, thus controlling mean stress effects on imperfection growth in steel pipelines under a near neutral pH environment. This study shows that prescriptive mean load pressure fluctuations can be used to reduce crack growth rates in steel pipelines, thus expanding pipeline integrity management methods.