Composite insulation materials are an inseparable part of numerous electrical devices because of synergy effect between their individual parts. One of the main aims of the presented study is an introduction of the dielectric properties of nanoscale magnesium oxide powder via Broadband Dielectric Spectroscopy (BDS). These unique results present the behavior of relative permittivity and loss factor in frequency and temperature range. Following the current trends in the application of inorganic nanofillers, this article is complemented by the study of dielectric properties (dielectric strength, volume resistivity, dissipation factor and relative permittivity) of epoxy-based composites depending on the filler amount (0, 0.5, 0.75, 1 and 1.25 weight percent). These parameters are the most important for the design and development of the insulation systems. The X-ray diffraction patterns are presented for pure resin and resin with optimal filler amount (1 wt %), which was estimated according to measurement results. Magnesium oxide nanoparticles were also treated by addition of silane coupling agent (γ-Glycidoxypropyltrimethoxysilane), in the case of optimal filler loading (1 wt %) as well. Besides previously mentioned parameters, the effects of surface functionalization have been observed by two unique measurement and evaluation techniques which have never been used for this evaluation, i.e., reduced resorption curves (RRCs) and voltage response method (VR). These methods (developed in our departments), extend the possibilities of measurement of composite dielectric responses related to DC voltage application, allow the facile comparability of different materials and could be used for dispersion level evaluation. This fact has been confirmed by X-ray diffraction analyses.

This article adds more information to the problem of natural ester use as an electroinsulating fluid in cellulose paper-oil systems, e.g., for use in power transformers. An accelerated thermal aging (120, 140 and 160 • C) of samples consisting of cellulose paper (transformerboard), a treated natural ester (filtered, basic Al 2 O 3 , 0.53% DBPC), a copper plate and moisture was studied. Research was especially focused on the impact of moisture on the aging of the above system. Samples with three different oil moisture levels (80, 143 and 305 ppm water content) were subjected to thermal aging to display the change in a selection of properties (tanδ, acid number, water content). For a study of the polarization effects, broadband dielectric spectroscopy (BDS) was performed to observe the complex permittivity and conductivity dependencies on the temperature and frequency (±30 • C, 0.01-10 7 Hz). Havriliak-Negami (H-N) diagrams were used to further understand the results. The degradation products during thermal aging were recognized by Fourier transform infrared (FT-IR) spectroscopy. Hydrolysis and hydrogenation occurred in the insulating system with a natural ester aged by elevated temperatures, which is in contrast to CO 2 formation in the case of electric aging. The results showed an increase in the acid number, dissipation factor, and number of hydrolysis and hydrogenation products. Furthermore, changes in polarization were observed as a consequence of the thermal aging of paper-natural ester insulation system with the presence of copper and moisture. INDEX TERMS Aging, dielectrics, hydrogenation, hydrolysis, oil insulation, paper-oil insulating system, natural ester, complex permittivity.

The influence of different concentrations (0.5, 1.0, and 2.0 wt.%) of Zinc Oxide (ZnO) filler on the dielectric properties of the cold-curing polyurethane (PU) resin is presented in this study. For this purpose, the direct DC conductivity and the broadband dielectric spectroscopy measurements were used to describe the changes in dielectric responses of PU/ZnO nanocomposites over the frequency and temperature range, respectively. It can be stated that, the 1.0 wt.% nanoparticles and lower caused a decrease in the real relative permittivity compared to the pure PU resin, while the higher concentration of nanoparticles for frequencies above 1 Hz had the opposite effect. The presence of nanoparticles in the polyurethane resin affected the segmental dynamics of the polymer chain and changed a charge distribution in the given system. These changes caused a shift of local relaxation peaks in the spectra of imaginary permittivity and dissipation factor of nanocomposites. It is suggested that the temperature-dependent transition of the electric properties in the nano-composite is closely associated with the α-relaxation and intermediate dipolar effects (IDE).

No abstract

The influence of various types of nanoparticle fillers with the same diameter of 20 nm were separately incorporated into a single component impregnating resin based on a polyesterimide (PEI) matrix and its subsequent changes in complex relative permittivity were studied. In this paper, nanoparticles of Al2O3 and ZnO were dispersed into PEI (with 0.5 and 1 wt.%) to prepare nanocomposite polymer. Dielectric frequency spectroscopy was used to measure the dependence of the real and imaginary parts of complex relative permittivity within the frequency range of 1 mHz to 1 MHz at a temperature range from +20 °C to +120 °C. The presence of weight concentration of nanoparticles in the PEI resin has an impact on the segmental dynamics of the polymer chain and changed the charge distribution in the given system. The changes detected in the 1H NMR spectra confirm that dispersed nanoparticles in PEI lead to the formation of loose structures, which results in higher polymer chain mobility. A shift of the local relaxation peaks, corresponding to the α-relaxation process, and higher mobility of the polymer chains in the spectra of imaginary permittivity of the investigated nanocomposites was observed.