The aim of this in vitro study was to test the effect of microinjection (Mi) of foreign gene into the rabbit egg pronucleus and epidermal growth factor (EGF) addition on the blastocyst rate, the cell number and the diameter of embryos, and to determine possible relationships between embryo cell number and embryo diameter. Blastocyst rate was significantly decreased in gene-Mi (G-Mi/E0) group (63.1%) comparing to intact ones (83.5%, p 1 <0.05). The addition of EGF at 20ng/ml (G-Mi/E20) or 200 ng/ml (G-Mi/E200) to gene-Mi embryos did not affect blastocyst rate (65.6 and 55.2% resp.). As a control for Mi, the eggs were microinjected with the same volume of phosphate-buffered solution (PBS-Mi) instead of the gene construct solution. Cell numbers and embryo diameters were measured from embryo images obtained on confocal laser scanning microscope. Bonferroni-modified LSD test showed that the embryo cell number in PBS-Mi group was significantly lower (p 1 <0.05) and in gene-Mi group was tended to decrease compared with intact embryos. Embryo diameter was not different among experimental groups. No effect of EGF given at any doses both on the cell number and embryo diameter was found. A positive correlation between cell number and embryo diameter was observed in all groups of embryos. Since embryo diameter was not changed under the influence of Mi or EGF addition in this study, this seems to be more conservative characteristics of the embryo morphology. These results suggest that the pronuclear microinjection compromises developmental potential of embryos, decreasing blastocyst rate and embryo cell number, whilst embryo diameter is not affected. No effects of EGF on studied parameters were confirmed. Declined quality of Mi-derived embryos is caused by the microinjection procedure itself, rather than by the gene construct used.