We present a unified device model for single layer organic light emitting diodes (LEDs) which includes charge injection, transport, and space charge effects in the organic material. The model can describe both injection limited and space charge limited current flow and the transition between them. We specifically considered cases in which the energy barrier to injection of electrons is much larger than that for holes so that holes dominate the current flow in the device. Charge injection into the organic material occurs by thermionic emission and by tunneling. For Schottky energy barriers less than about 0.3–0.4 eV, for typical organic LED device parameters, the current flow is space charge limited and the electric field in the structure is highly nonuniform. For larger energy barriers the current flow is injection limited. In the injection limited regime, the net injected charge is relatively small, the electric field is nearly uniform, and space charge effects are not important. At smaller bias in the injection limited regime, thermionic emission is the dominant injection mechanism. For this case the thermionic emission injection current and a backward flowing interface recombination current, which is the time reversed process of thermionic emission, combine to establish a quasi-equilibrium carrier density. The quasi-equilibrium density is bias dependent because of image force lowering of the injection barrier. The net device current is determined by the drift of these carriers in the nearly constant electric field. The net device current is much smaller than either the thermionic emission or interface recombination current which nearly cancel. At higher bias, injection is dominated by tunneling. The bias at which tunneling exceeds thermionic emission depends on the size of the Schottky energy barrier. When tunneling is the dominant injection mechanism, a combination of tunneling injection current and the backflowing interface recombination current combine to establish the carrier density. We compare the model results with experimental measurements on devices fabricated using the electroluminescent conjugated polymer poly[2-methoxy, 5-(2′-ethyl-hexyloxy)-1,4-phenylene vinylene] which by changing the contacts can show either injection limited behavior or space charge limited behavior.

Analysis of metal-oxide-based charge generation layers used in stacked organic light-emitting diodes

We present device model calculations for the current–voltage (I–V) characteristics of organic diodes and compare them with measurements of structures fabricated using MEH-PPV. The measured I–V characteristics have a Fowler–Nordheim (FN) functional form, but are more than three orders of magnitude smaller than the calculated FN tunneling current. We find that the low mobility of the organic materials leads to a large backflow of injected carriers into the injecting contact. These results account for the experimental observations and also demonstrate how transport layers in multilayer organic light-emitting diodes can be used to improve carrier injection.

Organic materials that have desirable luminescence properties, such as a favorable emission spectrum and high luminescence efficiency, are not necessarily suitable for single layer organic light-emitting diodes (LEDs) because the material may have unequal carrier mobilities or contact limited injection properties. As a result, single layer LEDs made from such organic materials are inefficient. In this article, we present device model calculations of single layer and bilayer organic LED characteristics that demonstrate the improvements in device performance that can occur in bilayer devices. We first consider an organic material where the mobilities of the electrons and holes are significantly different. The role of the bilayer structure in this case is to move the recombination away from the electrode that injects the low mobility carrier. We then consider an organic material with equal electron and hole mobilities but where it is not possible to make a good contact for one carrier type, say electrons. The role of a bilayer structure in this case is to prevent the holes from traversing the device without recombining. In both cases, single layer device limitations can be overcome by employing a two organic layer structure. The results are discussed using the calculated spatial variation of the carrier densities, electric field, and recombination rate density in the structures.

We present experimental and device model results for the current–voltage characteristics of a series of organic diodes. We consider three general types of structures: electron only, hole only, and bipolar devices. Electron and hole mobility parameters are extracted from the corresponding single carrier structures and then used to describe the bipolar devices. The device model successfully describes the experimental results for: electron only devices as thickness is varied, hole only devices as the contact metals are varied, and bipolar devices are both the thickness and the contact metals are varied.