[1] The shortening between the African and the Iberian plates is absorbed by a number of faults distributed over a very wide zone with very low slip rates and long periods of seismic loading. Thus a seismotectonic map based only on faults associated with seismicity or with expressive geomorphic features is incomplete. It is possible to characterize seismogenic faults using paleoseismology. First, paleoseismological results based on trenching analysis in the eastern Betics (Lorca-Totana segment of the Alhama de Murcia fault) are presented. The main paleoseismic parameters of this fault segment are (1) a minimum of two to three M w 6.5-7 earthquakes in the last 27 kyr (shortly before 1650 A.D., between 830 and 2130 B.C. and shortly before 16.7 ka, respectively), with a mean recurrence period of 14 kyr, and a very short elapsed time, and (2) a net slip rate of 0.07-0.6 mm/yr during the last 30 kyr. These results were extrapolated to the rest of the known active faults in the eastern Betics and were added to the slip rates of the active faults at the African margin. The total slip rate of the transect, which crosses de Alhama de Murcia fault in Spain and reaches the Cheliff basin (Algeria), would represent 21-82% of the total shortening between Africa and Eurasia estimated from plate motion models and seismic moment summation. A number of factors could account for this discrepancy: (1) hidden seismogenic faults in the emerged areas, (2) absence of correlation between current and late Pleistocene slip rates, (3) extensive small faults that are undetected and that absorb a significant amount of the deformation, and (4) possible overestimation of the convergence rates.

A compilation and a critical assessment of the 14C data set available show that the chronology of glacial events in the Pyrenees is not well constrained. After reviewing the literature on glacial reconstruction, we suggest a simplified subdivision of the Pyrenean last glacial cycle record into Last Pleniglacial, Deglaciation, and Neoglacial. To improve the numerical glacial chronology, we provide 10Be surface exposure ages for 5 glacial erosion surfaces, 9 moraines and 2 erratics in the Upper noguera Ribagorc-ana Valley (south-central Pyrenees). Published corrected 14C data and new 10Be exposure ages indicate that the major phase of moraine building recorded in this valley during the Last Pleniglacial probably occurred after 25 ka BP. This age calls in question the generally accepted hypothesis of a very early deglaciation of the Pyrenees ca 70–40 ka BP, and strongly suggests that the Pyrenees could have been in pleniglacial conditions during the Last Glacial Maximum (LGM). However, we do not exclude the possibility that the maximum glacier extent during the last glacial cycle had taken place much earlier than the LGM, as indicated by some published U-Th, AMS 14C and OSL data. We suggest that pleniglacial conditions could have taken place during a longer (b30–20 ka) period than generally assumed, and that the Last Pleniglacial could include several glacier fluctuations recorded irregularly in different valleys, with a last major glacier readvance taking place around the LGM. In addition, the Deglaciation is represented by a series of moraines deposited between ca 13.770.9 and 10.170.6 ka. This moraine series indicates a highly variable climatic pattern that is partly correlated with Greenland Stadial 1 (the Younger Dryas), and suggests that the Deglaciation could have continued into the early Holocene

No abstract

In intra-plate regions with low-seismic activity, seismic cycles last between 10 3 and 10 5 years and, consequently, quiescent faults may be capable of producing catastrophic earthquakes. Paleoseismic studies, which are necessary to define capable faults in these regions and to establish their seismic parameters, are scarce and not always possible. In order to overcome the scarcity of paleoseismic data, this paper proposes an approach to evaluate the capability and seismic parameters of faults. This approach takes into account instrumental, historical, paleoseismological and geological data. Assuming that in a given structural region with definite climatic and geological characteristics similar geomorphic features reflect a similar structural-seismic evolution, the capability of faults is established by comparing the fault related geomorphic features of the few proven seismogenic faults with those of the rest of the faults. The seismic parameters were estimated using some mathematical relationships from geological and geomorphological data, where the slip rate of the faults was determined from geological and geomorphological criteria. The case of eastern Iberia is presented to illustrate this approach. This area is characterized by low seismicity, few historical destructive earthquakes, and only one fault with good paleoseismological data. Of the 249 potential faults (longer than 10 km and adequately oriented with respect to the current stress field), 23 were regarded as capable faults. Some of these were located in seismic quiescent areas, and their main seismic parameters were estimated.

The Cerdanya basin was formed during dextral slip along the NE-SW La Tet fault (eastern Pyrenees) which formed a horsetail structure at its SW end. The resulting basin is clearly asymmetrical, formed by several basement blocks tilted towards the La Tet fault and limited by E-W faults.These faults absorbed the movement along the major strike-slip fault. The early basin evolution (Middle-Late Miocene) resulted from strike-slip, while the later evolution (Early Pliocene) involved a generally extensional regime.