Cheddar cheese ripening involves the conversion of lactose to glucose and galactose or galactose-6-phosphate by starter and nonstarter lactic acid bacteria. Under ideal conditions (i.e., where bacteria grow under no stress of pH, water activity, and salt), these sugars are mainly converted to lactic acid. However, during ripening of cheese, survival and growth of bacteria occurs under the stressed condition of low pH, low water activity, and high salt content. This forces bacteria to use alternate biochemical pathways resulting in production of other organic acids. The objective of this study was to determine if the level and type of organic acids produced during ripening was influenced by calcium (Ca) and phosphorus (P), residual lactose, and salt-to-moisture ratio (S/M) of cheese. Eight cheeses with 2 levels of Ca and P (0.67 and 0.47% vs. 0.53 and 0.39%, respectively), lactose at pressing (2.4 vs. 0.78%), and S/M (6.4 vs. 4.8%) were manufactured. The cheeses were analyzed for organic acids (citric, orotic, pyruvic, lactic, formic, uric, acetic, propanoic, and butyric acids) and residual sugars (lactose, galactose) during 48 wk of ripening using an HPLC-based method. Different factors influenced changes in concentration of residual sugars and organic acids during ripening and are discussed in detail. Our results indicated that the largest decrease in lactose and the largest increase in lactic acid occurred between salting and d 1 of ripening. It was interesting to observe that although the lactose content in cheese was influenced by several factors (Ca and P, residual lactose, and S/M), the concentration of lactic acid was influenced only by S/M. More lactic acid was produced in low S/M treatments compared with high S/M treatments. Although surprising for Cheddar cheese, a substantial amount (0.2 to 0.4%) of galactose was observed throughout ripening in all treatments. Minor changes in the levels of citric, uric, butyric, and propanoic acids were observed during early ripening, whereas during later ripening, a substantial increase was observed. A gradual decrease in orotic acid and a gradual increase in pyruvic acid content of the cheeses were observed during 12 mo of ripening. In contrast, acetic acid did not show a particular trend, indicating its role as an intermediate in a biochemical pathway, rather than a final product.

Eight Cheddar cheeses with 2 levels of calcium (Ca) and phosphorus (P), residual lactose, and salt-to-moisture ratio (S/M) were manufactured. All cheeses were made using a stirred-curd procedure and were replicated 3 times. Treatments with a high level of Ca and P were produced by setting the milk and drawing the whey at a higher pH (6.6 and 6.3, respectively) compared with the treatments with a low level of Ca and P (pH of 6.2 and 5.7, respectively). The lactose content in the cheeses was varied by adding lactose (2.5% by weight of milk) to the milk for high lactose cheeses, and washing the curd for low lactose cheeses. The difference in S/M was obtained by dividing the curds into halves, weighing each half, and salting at 3.5 and 2.25% of the weight of the curd for high and low S/M, respectively. All cheeses were salted at a pH of 5.4. Modifications in cheese-making protocols produced cheeses with desired differences in Ca and P, residual lactose, and S/M. Average Ca and P in the high Ca and P cheeses was 0.68 and 0.48%, respectively, vs. 0.53 and 0.41% for the low Ca and P cheeses. Average lactose content of the high lactose treatments at d 1 was 1.48% compared with 0.30% for the low lactose treatments. The S/M for the high and low S/M cheeses was 6.68 and 4.77%, respectively. Mean moisture, fat, and protein content of the cheeses ranged from 32.07 to 37.57%, 33.32 to 35.93%, and 24.46 to 26.40%, respectively. The moisture content differed among the treatments, whereas fat and protein content on dry basis was similar.

The texture profile analysis (TPA) parameters and meltability of Cheddar cheeses with varying levels of calcium (Ca) and phosphorus (P) content, residual lactose content and salt-to-moisture (S/M) ratio were studied at 0, 1, 2, 4, 6 and 8 months of ripening. The TPA hardness had an inverse relationship with the meltability of Cheddar cheese and at any given ripening time, lower TPA hardness corresponded to higher meltability of Cheddar cheese. Higher Ca and P content (0.67% Ca and 0.53% P) in Cheddar cheese resulted in up to 22.8, 5.7, 14.6, 13.5 and 35.2% increase in hardness, springiness, cohesiveness, resilience and chewiness values, respectively, and up to 23.5 and 27.7% decrease in meltability and adhesiveness values during ripening compared to the Cheddar cheese prepared with lower Ca and P content (0.53% Ca and 0.39% P). Higher residual lactose content (1.4%) in Cheddar cheese resulted in up to 24.6, 8.8 and 20.0% increase in hardness, cohesiveness and chewiness values, respectively, and up to 12.7% decrease in meltability value in the Cheddar cheese during ripening compared to the lower lactose content (0.78%). High S/M ratio (6.4) resulted in up to 29.4, 30.3 and 29.4% increase in hardness, adhesiveness and chewiness values, respectively, and up to 7.3% decrease in meltability value in Cheddar cheese compared to low S/M ratio (4.8) during ripening.3 Corresponding

The objective of this study was to develop methods for the estimation and fortification of vitamin D3 in pasteurized Process cheese. Vitamin D3 was estimated using alkaline saponification at 70 degrees C for 30 min, followed by extraction with petroleum ether:diethyl ether (90:10 vol/vol) and HPLC. The retention time for vitamin D3 was approximately 9 min. A standard curve with a correlation coefficient of 0.972 was prepared for quantification of vitamin D3 in unknown samples. In the second phase of the study, pasteurized Process cheeses fortified with commercial water- or fat-dispersible forms of vitamin D3 at a level of 100 IU per serving (28 g) were manufactured. There was no loss of vitamin D3 during Process cheese manufacture, and the vitamin was uniformly distributed. No losses of the vitamin occurred during storage of the fortified cheeses over a 9-mo period at 21 to 29 degrees C and 4 to 6 degrees C. There was an approximately 25 to 30% loss of the vitamin when cheeses were heated for 5 min in an oven maintained at 232 degrees C. Added vitamin D3 did not impart any off flavors to the Process cheeses as determined by sensory analysis. There were no differences between the water- and fat-dispersible forms of the vitamin in the parameters measured in fortified cheeses.

The pH of cheese is an important attribute that influences its quality. Substantial changes in cheese pH are often observed during ripening. A combined effect of calcium, phosphorus, residual lactose, and salt-to-moisture ratio (S/M) of the cheese on the changes in cheese pH during ripening was investigated. Eight cheeses with 2 levels of Ca and P (0.67 and 0.47% vs. 0.53 and 0.39%, respectively), lactose at pressing (2.4 vs. 0.78%), and S/M (6.4 vs. 4.8%) were manufactured. All the cheeses were salted at a pH of 5.4, pressed for 5 h, and then ripened at 6 to 8 degrees C. The pH of the salted curds before pressing and the cheeses during 48 wk of ripening was measured. Also, cheeses were analyzed for water-soluble Ca and P, organic P, and bound inorganic P during ripening. Changes in organic acids' concentration and shifts in the distribution of Ca and P between different forms were studied in relation to changes in pH. Cheeses with low S/M exhibited a larger increase in acid production during ripening compared with high S/M cheeses. Cheeses with the highest concentration of bound inorganic P exhibited the highest pH, whereas cheeses with the lowest concentration of bound inorganic P exhibited the lowest pH among the 8 treatments. Although conversion of lactose to short-chain, water-soluble organic acids decreased cheese pH, bound inorganic phosphate buffered the changes in cheese pH. Production of acid in excess of the buffering capacity (which was the case in low Ca and P and low S/M treatments) led to a low pH, whereas solubilization of bound inorganic P in excess to acid production (which was the case in high Ca and P and high S/M treatments) led to an increase in pH. However, for cheeses with high Ca and P and low S/M, changes in cheese pH were influenced by the level of residual lactose. Hence, pH changes in Cheddar cheese can be modulated by a concomitant control on the amount and state of Ca and P, level of residual lactose, and S/M of the cheese.