This paper presents the optimal conditions for fast transfer of solid particle with an airlift pump. The experimental examinations were carried out in an airlift pump with a length of 5.64 m and an inner diameter of 0.102 m in order to determine the impact of submergence ratio, air flow, and physical particle properties, such as shape, size, and density, on the vertical velocity of the particle in detail. The results showed that with the same air flow, the maximum particle velocity was achieved when the churn flow regime is established with a submergence ratio close to 0.89. However, in bubble and slug flow, it is not possible to carry a large particle in the dimensions of centimeters. Furthermore, in a churn flow, the velocity of the particle exceeds the velocity of pumped water; hence, water is not the only particle carrier in a vertical three-phase flow.

This paper presents experimental studies on the optimization of air–water flow in an airlift pump. Airlift pumps use compressed gas to verticall transport liquids and slurries. Due to the lack of theoretical equations for designing and predicting flow regimes, experimental investigations must be carried out to find the best condition to operate an airlift pump at high efficiency. We used a new air injection system and different submergence ratios to evaluate the output of a simple pump for vertical displacement of water in an underground mine. The tests were carried out in a new device with 5.64 m height and 10.2 cm circular riser pipe. Three air-jacket pipes, at different gas flows in the range of 0.002–0.09 m3/s were investigated with eight submergence ratios. It was found that with the same air flow rate, the most efficient flow of water was achieved when an air jacket with 3 mm diameter holes was used with a submergence ratio between 0.6 and 0.75. In addition, a comparison of practical results with two theoretical models proposed by other investigators showed that neither was able to accurately predict airlift performance in air–water flow mode.

One of the crucial aspects of reducing air consumption when conveying particles with an airlift pump is to know the factors that affect the process of particle motion at an initial velocity of zero. To determine the influence of submergence ratio and physical properties of particles (such as size, shape, and mass) on the onset of vertical particle motion, the airlift pump was taken as the research object, and spherical glass together with irregular shaped coal were used as experimental test particles. The results show that unlike the water-solid environment, the start of particle motion in the water-air mixture does not always occur at a certain value of superficial water velocity and this value also increases with increasing submergence level. Among the parameters considered, the role of submergence ratio is much more effective than the dimensions and the shape of the particle, because by increasing submergence from 0.3 to 0.8, it is possible to reduce air consumption by up to 8 times. Based on this study the corresponding theoretical model derived by Fujimoto et al. is optimized, wherein the overall agreement between the modified theory and present experimental data is particularly good. Contrary to Fujimoto, the minimum superficial water velocity for lifting solids in the air-water mixture is not always smaller than water ambient which indicates on optimum submergence ratio higher than 0.7. Finally, a new criterion was introduced to describe the moment of onset of the particle motion as a function of the superficial fluid velocity ratio for each submergence value.