Purpose To perform a detailed deformity analysis of patients with varus alignment and to define the ideal osteotomy level (tibial vs. femoral vs. double level) to avoid an oblique joint line. Methods A total of 303 digital full-leg standing radiographs of patients aged 18-60 years and varus alignment [mechanical tibiofemoral varus angle (mFTA) ≥ 3°] were included. All legs were analyzed regarding mFTA, mechanical medial proximal tibia angle (mMPTA), mechanical lateral distal femur angle (mLDFA), and joint line convergence angle. Based on mFTA, varus alignment was categorized as "mild" (3°-5°), "moderate" (6°-8°), or "severe" (≥ 9°). Deformity location was determined according to the malalignment test described by Paley. Two osteotomy simulations were performed with different upper limits for mMPTA: anatomic correction (mMPTA ≤ 90°, mLDFA ≥ 85°) and overcorrection (mMPTA ≤ 95°, mLDFA ≥ 85°). If a single osteotomy exceeded these limits at the intended mFTA of 2° valgus, a double-level osteotomy was simulated. If even a double-level osteotomy resulted in deviations from the defined limits, the leg was categorized as "uncorrectable". Results Mean mFTA was 6° ± 11° of varus (range 3°-15°). A tibial deformity was observed in 28%, a femoral deformity in 23%, a combined tibial and femoral deformity in 4%, and no bony deformity in 45%. The prevalence of a tibial deformity did not differ between varus severity groups, whereas a femoral and bifocal deformity was significantly more prevalent in knees with more distinct varus (p < 0.001). Osteotomy simulation revealed that isolated high tibial osteotomy (HTO) was appropriate in only 12% for anatomic correction, whereas a double-level osteotomy was necessary in 63%. If overcorrection of mMPTA was tolerated, the number of HTOs significantly increased to 57% (p < 0.001), whereas the number of doublelevel osteotomies significantly decreased to 33% (p < 0.001). Isolated DFO was considered ideal in 8% for both simulations. Significantly more knees were considered "uncorrectable" by simulating anatomic correction (18 vs. 2%; p < 0.001). A double-level osteotomy was significantly more often necessary in knees with "severe" varus (p < 0.001). Conclusion Less than one-third of patients (28%) with mechanical varus ≥ 3° have a tibial deformity. If anatomic correction (mMPTA ≤ 90°) is intended, only 12% of patients can be corrected via isolated HTO, whereas 63% of patients require a double-level osteotomy. If slight overcorrection is accepted (mMPTA ≤ 95°), 57% of patients can be corrected via isolated HTO, whereas 33% of patients would still require a double-level osteotomy. Level of evidence III, cross-sectional study.

No abstract

Purpose To evaluate the incidence and morphology of medial cortical hinge fractures in lateral open wedge distal femoral osteotomy (LOW-DFO) and to determine a safe zone for the position of the osteotomy hinge to minimize the risk of hinge fractures. Methods Consecutive patients who underwent LOW-DFO for symptomatic valgus malalignment were screened for eligibility for this retrospective observational cohort study. Demographical and surgical data were collected. The incidence and morphology of medial cortical hinge fractures were evaluated on standard postoperative anterior–posterior knee radiographs. Comprehensive measurements evaluating the osteotomy gap and the position of the osteotomy hinge were taken. Additionally, each osteotomy hinge was assigned to a corresponding sector of a proposed five-sector grid of the distal medial femur. Results A total of 100 patients (60% female) with a mean age of 31 ± 13 years were included. The overall incidence of medial cortical hinge fractures was 46% and three distinct fracture types were identified. The most frequently observed fracture type was extension of the osteotomy gap (76%), followed by a proximal (20%) and distal (4%) course of the fracture line in relation to the hinge. Group comparison (hinge fracture vs. no hinge fracture) showed statistically significant higher values for the height of the osteotomy gap (p = 0.001), the wedge angle (p = 0.036), and the vertical distance between the hinge and the proximal margin of the adductor tubercle (AT; p = 0.002) in the hinge fracture group. Furthermore, a significantly lower horizontal distance between the hinge and the medial cortical bone (p = 0.036) was observed in the hinge fracture group. A statistically significant higher incidence of medial cortical hinge fractures was observed when the position of the osteotomy hinge was proximal compared to distal to the proximal margin of the AT (53% vs. 27%; p = 0.023). Conclusion Medial cortical hinge fractures in LOW-DFO are a common finding with three distinct fracture types. To minimize the risk of medial cortical hinge fractures, it is recommended to aim for a position of the osteotomy hinge at the level of or distal to the proximal margin of the adductor tubercle. Level of evidence Prognostic study; Level III

Purpose To evaluate the incidence, morphology, and associated complications of medial cortical hinge fractures after lateral closing wedge distal femoral osteotomy (LCW-DFO) for varus malalignment and to identify constitutional and technical factors predisposing for hinge fracture and consecutive complications. Methods Seventy-nine consecutive patients with a mean age of 47 ± 12 years who underwent LCW-DFO for symptomatic varus malalignment at the authors’ institution between 01/2007 and 03/2018 with a minimum of 2-year postoperative time interval were enrolled in this retrospective observational study. Demographic and surgical data were collected. Measurements evaluating the osteotomy cut (length, wedge height, hinge angle) and the location of the hinge (craniocaudal and mediolateral orientation, relation to the adductor tubercle) were conducted on postoperative anterior–posterior knee radiographs and the incidence and morphology of medial cortical hinge fractures was assessed. A risk factor analysis of constitutional and technical factors predisposing for the incidence of a medial cortical hinge fracture and consecutive complications was conducted. Results The incidence of medial cortical hinge fractures was 48%. The most frequent morphological type was an extension fracture type (68%), followed by a proximal (21%) and distal fracture type (11%). An increased length of the osteotomy in mm (53.1 ± 10.9 vs. 57.7 ± 9.6; p = 0.049), an increased height of the excised wedge in mm (6.5 ± 1.9 vs. 7.9 ± 3; p = 0.040) as well as a hinge location in the medial sector of an established sector grid (p = 0.049) were shown to significantly predispose for the incidence of a medial cortical hinge fracture. The incidence of malunion after hinge fracture (14%) was significantly increased after mediolateral dislocation of the medial cortical bone > 2 mm (p < 0.05). Conclusion Medial cortical hinge fractures after LCW-DFO are a common finding. An increased risk of sustaining a hinge fracture has to be expected with increasing osteotomy wedge height and a hinge position close to the medial cortex. Furthermore, dislocation of a medial hinge fracture > 2 mm was associated with malunion and should, therefore, be avoided. Level of evidence Prognostic study; Level IV.