The presence or absence of gas phase species during combustion of aluminum nanoparticles (n-Al) is a crucial observable in evaluating competing theories such as a diffusive oxidation mechanism and the melt dispersion mechanism. Absorption spectroscopy was used to probe the ground state of aluminum monoxide (AlO) and Al vapor in order to quantify the amount of Al and AlO present under conditions where these species were not observed in emission previously. Absorption measurements were made during combustion of nanoaluminum and micron-sized aluminum in a heterogeneous shock tube. AlO was detected in absorption at temperatures as low as 2000 K in n-Al combustion, slightly below the limit seen in micro-Al combustion. Al vapor was detected during n-Al combustion at temperatures as low as 1500 K, significantly lower than in micro-Al combustion, suggestive of a gas phase component. The detection limit for Al vapor was 1 Â 10 12 cm À3 . The gas phase component was much weaker than that seen in 10 lm Al combustion. A comparison with n-Al in an inert environment did not show Al vapor at temperatures below 2300 K, even though the equilibrium concentration of Al from particles at that temperature were several orders of magnitude higher than the detection limit. This suggests a nearly pristine oxide coat that inhibits the production of Al vapor in appreciable quantities without reaction. These results are contrary to predictions of the melt dispersion mechanism, which should result in the generation of aluminum vapor from high-energy Al clusters produced from n-Al particles that spallate from mechanical stresses under rapid heating. This should further be independent of the bath gas.
The recombination of allyl radicals (C3H5), generated from the dissociation of 1,5-hexadiene or allyl iodide dilute in krypton, has been investigated in a diaphragmless shock tube using laser schlieren densitometry, LS, (900-1700 K, 10 ± 1, 29 ± 3, 57 ± 3, and 120 ± 4 Torr). The LS density gradient profiles were simulated and excellent agreement was found between simulations and experimental profiles. Rate coefficients for C3H5I → C3H5 + I and C3H5 + C3H5 → C6H10 were obtained and showed strong fall-off. Second order rate coefficients for allyl radical recombination were determined as k(1a,124Torr) = (2.6 ± 0.8) × 10(55)T( -12.995) exp(-8426/T), k(1a,57Torr) = (1.7 ± 0.5) × 10(60)T( -14.49) exp(-9344/T), and k(1a,30Torr) = (7.5 ± 2.3) × 10(66)T( -15.935) exp(-10192/T) cm(3) mol(-1)s(-1). The contribution of a disproportionation channel in allyl radical reactions was assessed, and the best agreement was obtained with no more than 5% disproportionation. Notably, because both the forward and back reactions of C6H10 ⇌ C3H5 + C3H5 were measured, utilizing two different precursors, the equilibrium constant of this reaction could be found, suggesting an entropy of formation of 1,5-hexadiene, 87.3 cal mol(-1 )K(-1), which is significantly smaller than that group additivity predicts, but larger than other reference literature values.
The recombination and disproportionation of allyl radicals has been studied in a single pulse shock tube with gas chromatographic measurements at 1-10 bar, 650-1300 K, and 1.4-2 ms reaction times. 1,5-Hexadiene and allyl iodide were used as precursors. Simulation of the results using derived rate expressions from a complementary diaphragmless shock tube/laser schlieren densitometry study provided excellent agreement with precursor consumption and formation of all major stable intermediates. No significant pressure dependence was observed at the present conditions. It was found that under the conditions of these experiments, reactions of allyl radicals in the cooling wave had to be accounted for to accurately simulate the experimental results, and this unusual situation is discussed. In the allyl iodide experiments, higher amounts of allene, propene, and benzene were found at lower temperatures than expected. Possible mechanisms are discussed and suggest that iodine containing species are responsible for the low temperature formation of allene, propene, and benzene.
A miniature high repetition rate shock tube with excellent reproducibility has been constructed to facilitate high temperature, high pressure, gas phase experiments at facilities such as synchrotron light sources where space is limited and many experiments need to be averaged to obtain adequate signal levels. The shock tube is designed to generate reaction conditions of T > 600 K, P < 100 bars at a cycle rate of up to 4 Hz. The design of the apparatus is discussed in detail, and data are presented to demonstrate that well-formed shock waves with predictable characteristics are created, repeatably. Two synchrotron-based experiments using this apparatus are also briefly described here, demonstrating the potential of the shock tube for research at synchrotron light sources.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.