The solid lithium-ion electrolyte ''Li 7 La 3 Zr 2 O 12 '' (LLZO) with a garnet-type structure has been prepared in the cubic and tetragonal modification following conventional ceramic syntheses routes. Without aluminium doping tetragonal LLZO was obtained, which shows a two orders of magnitude lower room temperature conductivity than the cubic modification. Small concentrations of Al in the order of 1 wt% were sufficient to stabilize the cubic phase, which is known as a fast lithium-ion conductor. The structure and ion dynamics of Al-doped cubic LLZO were studied by impedance spectroscopy, dc conductivity measurements, 6 Li and 7 Li NMR, XRD, neutron powder diffraction, and TEM precession electron diffraction. From the results we conclude that aluminium is incorporated in the garnet lattice on the tetrahedral 24d Li site, thus stabilizing the cubic LLZO modification. Simulations based on diffraction data show that even at the low temperature of 4 K the Li ions are blurred over various crystallographic sites. This strong Li ion disorder in cubic Al-stabilized LLZO contributes to the high conductivity observed. The Li jump rates and the activation energy probed by NMR are in very good agreement with the transport parameters obtained from electrical conductivity measurements. The activation energy E a characterizing longrange ion transport in the Al-stabilized cubic LLZO amounts to 0.34 eV. Total electric conductivities determined by ac impedance and a four point dc technique also agree very well and range from 1 Â 10 À4 Scm À1 to 4 Â 10 À4 Scm À1 depending on the Al content of the samples. The room temperature conductivity of Al-free tetragonal LLZO is about two orders of magnitude lower (2 Â 10 À6 Scm À1 , E a = 0.49 eV activation energy). The electronic partial conductivity of cubic LLZO was measured using the Hebb-Wagner polarization technique. The electronic transference number t eÀ is of the order of 10 À7. Thus, cubic LLZO is an almost exclusive lithium ion conductor at ambient temperature.

Al-contaminated Ta-substituted Li7La3Zr2O12 (LLZ:Ta), synthesized via solid-state reaction, and Al-free Ta-substituted Li7La3Zr2O12, fabricated by hot-press sintering (HP-LLZ:Ta), have relative densities of 92.7% and 99.0%, respectively. Impedance spectra show the total conductivity of LLZ:Ta to be 0.71 mS cm(-1) at 30 °C and that of HP-LLZ:Ta to be 1.18 mS cm(-1). The lower total conductivity for LLZ:Ta than HP-LLZ:Ta was attributed to the higher grain boundary resistance and lower relative density of LLZ:Ta, as confirmed by their microstructures. Constant direct current measurements of HP-LLZ:Ta with a current density of 0.5 mA cm(-2) suggest that the short circuit formation was neither due to the low relative density of the samples nor the reduction of Li-Al glassy phase at grain boundaries. TEM, EELS, and MAS NMR were used to prove that the short circuit was from Li dendrite formation inside HP-LLZ:Ta, which took place along the grain boundaries. The Li dendrite formation was found to be mostly due to the inhomogeneous contact between LLZ solid electrolyte and Li electrodes. By flatting the surface of the LLZ:Ta pellets and using thin layers of Au buffer to improve the contact between LLZ:Ta and Li electrodes, the interface resistance could be dramatically reduced, which results in short-circuit-free cells when running a current density of 0.5 mA cm(-2) through the pellets. Temperature-dependent stepped current density galvanostatic cyclings were also carried out to determine the critical current densities for the short circuit formation. The short circuit that still occurred at higher current density is due to the inhomogeneous dissolution and deposition of metallic Li at the interfaces of Li electrodes and LLZ solid electrolyte when cycling the cell at large current densities.

We review case studies of diffusion in nanocrystalline ceramics, i.e. polycrystalline non-metallic materials with average grain sizes typically in the range from 5 to 50 nm. The experimental methods applied are, on the one hand, tracer diffusion or conductivity methods which are sensitive to macroscopic transport, and, on the other hand, NMR techniques which, complementarily to the previous ones, give access to microscopic diffusion parameters like atomic hopping rates and jump barrier heights. In all cases the diffusion properties of the samples, whether single-phase systems or composites, are dominated by their grain boundaries and interfacial regions, respectively. In principle, all experimental techniques allow one to discriminate between contributions to the diffusion from the crystalline grains and those from the interfacial regions. Corresponding examples are presented for SIMS and impedance measurements on oxygen conductors. NMR studies for various nanocrystalline lithium ion conductors reveal that two lithium species with different diffusivities are present. Comparison with the coarse grained counterparts shows that the slower ions are located inside the crystallites and the faster ones in the structurally disordered interfacial regions. Investigations on composite materials exhibit phenomena which can be explained by the percolation of fast diffusion pathways being formed by the interfaces between the two components.

Gas transport through metal-organic framework membranes (MOFs) was switched in situ by applying an external electric field (E-field). The switching of gas permeation upon E-field polarization could be explained by the structural transformation of the zeolitic imidazolate framework ZIF-8 into polymorphs with more rigid lattices. Permeation measurements under a direct-current E-field poling of 500 volts per millimeter showed reversibly controlled switching of the ZIF-8 into polar polymorphs, which was confirmed by x-ray diffraction and ab initio calculations. The stiffening of the lattice causes a reduction in gas transport through the membrane and sharpens the molecular sieving capability. Dielectric spectroscopy, polarization, and deuterium nuclear magnetic resonance studies revealed low-frequency resonances of ZIF-8 that we attribute to lattice flexibility and linker movement. Upon E-field polarization, we observed a defibrillation of the different lattice motions.

The development of highly conductive solids is a rapidly growing research area in materials science. In particular, the study of Li-ion conductors is driven by the ambitious effort to design powerful lithium-ion batteries. A deeper understanding of Li dynamics in solids requires the availability of a large set of complementary techniques to probe Li self-diffusion on different length and time-scales. We report on (7)Li as well as (6)Li spin-alignment echo (SAE) nuclear magnetic resonance (NMR) spectroscopy, which is capable of probing long-range diffusion parameters from a microscopic, that is, atomic-scale, point of view. So far, variable-temperature SAE NMR spectroscopy has been applied to a number of polycrystalline and glassy Li-ion conductors. The materials investigated serve as model systems to unravel the interesting features of the technique in determining reliable Li jump rates and hopping activation energies. In particular, the latter are compared with those probed by macroscopic techniques such as dc-conductivity measurements that are sensitive to long-range translational motions.