Two diffractive optical elements are used to create a compact raster THz scanning setup in reflective configuration. The first one focuses the radiation into the small focal spot on the sample, while the second one collects reflected radiation and focuses it on the detector. To assure small size of the setup and large apertures of optical elements, structures work in the off-axis geometry. Thus, the focal spot is formed 100 mm after and 60 mm below the optical axis of the element, which measures 75 mm in diameter. The designed iterative algorithm allows further minimization of these values.

Recently, one of the most commonly discussed applications of terahertz radiation is wireless telecommunication. It is believed that the future 6G systems will utilize this frequency range. Although the exact technology of future telecommunication systems is not yet known, it is certain that methods for increasing their bandwidth should be investigated in advance. In this paper, we present the diffractive optical elements for the frequency division multiplexing of terahertz waves. The structures have been designed as a combination of a binary phase grating and a converging diffractive lens. The grating allows for differentiating the frequencies, while the lens assures separation and focusing at the finite distance. Designed structures have been manufactured from polyamide PA12 using the SLS 3D printer and verified experimentally. Simulations and experimental results are shown for different focal lengths. Moreover, parallel data transmission is shown for two channels of different carrier frequencies propagating in the same optical path. The designed structure allowed for detecting both signals independently without observable crosstalk. The proposed diffractive elements can work in a wide range of terahertz and sub-terahertz frequencies, depending on the design assumptions. Therefore, they can be considered as an appealing solution, regardless of the band finally used by the future telecommunication systems.

The redistribution of an incoming radiation into several beams is necessary in telecommunication to demultiplex data signals. In the terahertz spectral range, it can be realized by easy-to-manufacture diffractive optical elements (DOEs) allowing to focus the radiation into multiple focal spots in a single plane. In this article, we present diffractive optical elements focusing THz radiation into three focal spots. Different focal spot distributions (symmetric and asymmetric) are designed using an iterative algorithm. The phase distribution forming asymmetric focal spots can be realized by iterative design, which is a novel approach, to our knowledge. Then, the structures are manufactured using a sintering-based 3D-printing method from polyamide 12 (PA 12) and measured in an experimental setup for 150 GHz frequency. A novel approach based on neural networks (NNs) is proposed to optimize the phase delay maps of the structures to further improve their performance – the higher efficiency and the lower unwanted background noise.

Medical and many other applications require small-volume setups enabling terahertz imaging. Therefore, we aim to develop a device for the in-reflection examination of the samples. Thus, in this article, we focus on the diffractive elements for efficient redirection and focusing of the THz radiation. A terahertz diffractive optical structure has been designed, optimized, manufactured (using extrusion-based 3D printing) and tested. Two manufacturing methods have been used—direct printing of the structures from PA12, and casting of the paraffin structures out of 3D-printed molds. Also, the limitations of the off-axis focusing have been discussed. To increase the efficiency, an iterative algorithm has been proposed that optimizes off-axis structures to focus the radiation into small focal spots located far from the optical axis, at an angle of more than 30 degrees. Moreover, the application of higher-order kinoform structure design allowed the maintaining of the smallest details of the manufactured optical element, using 3D printing techniques.

No abstract