The study of the response of cancer cells to chemotherapy drugs is of high importance due to the specificity of some drugs to certain types of cancer and the resistance of some specific cancer types to chemotherapy drugs. Our aim was to develop and apply the label-free and non-destructive Fourier transform infrared (FTIR) method to determine the sensitivity of three different cancer cell-lines to a common anti-cancer drug doxorubicin at different concentrations and to demonstrate that information about the mechanism of resistance to the chemotherapy drug can be extracted from spectral data. HeLa, PC3, and Caco-2 cells were seeded and grown on an attenuated total reflection (ATR) crystal, doxorubicin was applied at the clinically significant concentration of 0.1-20 μM, and spectra of the cells were collected hourly over 20 h. Analysis of the amide bands was correlated with cell viability, which had been cross validated with MTT assays, allowing to determine that the three cell lines had significantly different resistance to doxorubicin. The difference spectra and principal component analysis (PCA) highlighted the subtle chemical changes in the living cells under treatment. Spectral regions assigned to nucleic acids (mainly 1085 cm(-1)) and carbohydrates (mainly 1024 cm(-1)) showed changes that could be related to the mode of action of the drug and the mechanism of resistance of the cell lines to doxorubicin. This is a cost-effective method that does not require bioassay reagents but allows label-free, non-destructive and in situ analysis of chemical changes in live cells, using standard FTIR equipment adapted to ATR measurements.

FTIR imaging is a label-free, non-destructive method valuably exploited in the study of the biological process in living cells. However, the long wavelength/low spatial resolution and the strong absorbance of water are still key constrains in the application of IR microscopy ex vivo. In this work, a new retrofit approach based on the use of ZnS hemispheres is introduced to significantly improve the spatial resolution on live cell FTIR imaging. By means of two high refractive index domes sandwiching the sample, a lateral resolution close to 2.2 μm at 6 μm wavelength has been achieved, i.e. below the theoretical diffraction limit in air and more than twice the improvement (to ~λ/2.7) from our previous attempt using CaF2 lenses. The ZnS domes also allowed an extended spectral range to 950 cm−1, in contrast to the cut-off at 1050 cm−1 using CaF2. In combination with synchrotron radiation source, microFTIR provides an improved signal-to-noise ratio through the circa 12 μm thin layer of medium, thus allowing detailed distribution of lipids, protein and nucleic acid in the surround of the nucleus of single living cells. Endoplasmic reticula were clearly shown based on the lipid ν(CH) and ν(C=O) bands, while the DNA was imaged based on the ν(PO2−) band highlighting the nucleus region. This work has also included a demonstration of drug (doxorubicin) in cell measurement to highlight the potential of this approach. Graphical abstract Electronic supplementary materialThe online version of this article (10.1007/s00216-018-1245-x) contains supplementary material, which is available to authorized users.

Fourier transform infrared (FT-IR) spectroscopic imaging and microscopy of single living cells are established label-free technique for the study of cell biology. The constant driver to improve the spatial resolution of the technique is due to the diffraction limit given by infrared (IR) wavelength making subcellular study challenging. Recently, we have reported, with the use of a prototype zinc sulfide (ZnS) transmission cell made of two hemispheres, that the spatial resolution is improved by the factor of the refractive index of ZnS, achieving a λ/2.7 spatial resolution using the synchrotron–IR microscopy with a 36× objective with numerical aperture of 0.5. To refine and to demonstrate that the ZnS hemisphere transmission device can be translated to standard bench-top FT-IR imaging systems, we have, in this work, modified the device to achieve a more precise path length, which has improved the spectral quality of the living cells, and showed for the first time that the device can be applied to study live cells with three different bench-top FT-IR imaging systems. We applied focal plane array (FPA) imaging, linear array, and a synchrotron radiation single-point scanning method and demonstrated that in all cases, subcellular details of individual living cells can be obtained. Results have shown that imaging with the FPA detector can measure the largest area in a given time, while measurements from the scanning methods produced a smoother image. Synchrotron radiation single-point mapping produced the best quality image and has the flexibility to introduce over sampling to produce images of cells with great details, but it is time consuming in scanning mode. In summary, this work has demonstrated that the ZnS hemispheres can be applied in all three spectroscopic approaches to improve the spatial resolution without any modification to the existing microscopes.

Quantifying the rate and the amount of drug entering live cells is an essential part of the medicine development process. Infrared spectroscopy is a label-free, chemically selective tool for analyzing the composition of live cells in culture that has the potential to quantify, in situ, the amount of drug entering living cells in a nondestructive manner, although its sensitivity is currently limited. This paper is the first to demonstrate in situ quantification of the cancer drug, fluorouracil, in live cells at a therapeutically relevant concentration using Fourier transform infrared spectroscopy. To achieve the required improvement in detection and quantitation limits of the IR measurement, two strategies were exploited. First, a sampling method called multibounce attenuated total reflection was used to optimize the signal while second, a long pass filter in combination with a mercury cadmium telluride detector was used to reduce the instrument noise. Using these novel adaptations, it was possible to quantify 20 μM of fluorouracil in cell culture medium using a standard FTIR instrument, while it was possible to quantify and measure the flux of fluorouracil in situ in living cells treated with an 80 μM drug.