A facile hydrothermal synthesis route to N and S, N co-doped graphene quantum dots (GQDs) was developed by using citric acid as the C source and urea or thiourea as N and S sources. Both N and S, N doped GQDs showed high quantum yield (78% and 71%), excitation independent under excitation of 340-400 nm and single exponential decay under UV excitation. A broad absorption band in the visible region appeared in S, N co-doped GQDs due to doping with sulfur, which alters the surface state of GQDs. However, S, N co-doped GQDs show different color emission under excitation of 420-520 nm due to their absorption in the visible region. The excellent photocatalytic performance of the S, N co-doped GQD/TiO2 composites was demonstrated by degradation of rhodamine B under visible light. The apparent rate of S, N:GQD/TiO2 is 3 and 10 times higher than that of N:GQD/TiO2 and P25 TiO2 under visible light irradiation, respectively.

Chromium(VI) [Cr(VI)] is considered as a severe environmental pollutant, due to its highly toxic and carcinogenic properties. Therefore, low cost, highly sensitive sensors for the determination of Cr(VI) are highly demanded. It is well-known that highly luminescent carbon dots (CDs) have been successfully applied as fluorescent nanosensors for pH, ions, and molecular substances. In the present work, we have demonstrated an on-off fluorescent CD probe for detecting Cr(VI) based on the inner filter effect (IFE) because the absorption bands of Cr(IV) fully covered the emission and excitation bands of CDs. This CD-based nanosensor provides obvious advantages of simplicity, convenience, rapid response, high selectivity, and sensitivity, which have potential application for the detection of Cr(VI) in the environmental industry. In addition, because Cr(VI) can be reduced to low valent chromium species easily by reductant, resulting in the elimination of the IFE and recovery of CD fluorescence, the CD-Cr(VI) mixture could behave as an off-on type fluorescent probe for reductant. We employed ascorbic acid (AA) as an example molecule to demonstrate this off-on type fluorescent probe.

Ion transport in crystalline fast ionic conductors is a complex physical phenomenon. Certain ionic species (e.g., Ag+, Cu+, Li+, F–, O2–, H+) in a solid crystalline framework can move as fast as in liquids. This property, although only observed in a limited number of materials, is a key enabler for a broad range of technologies, including batteries, fuel cells, and sensors. However, the mechanisms of ion transport in the crystal lattice of fast ionic conductors are still not fully understood despite the substantial progress achieved in the last 40 years, partly because of the wide range of length and time scales involved in the complex migration processes of ions in solids. Without a comprehensive understanding of these ion transport mechanisms, the rational design of new fast ionic conductors is not possible. In this review, we cover classical and emerging characterization techniques (both experimental and computational) that can be used to investigate ion transport processes in bulk crystalline inorganic materials which exhibit predominant ion conduction (i.e., negligible electronic conductivity) with a primary focus on literature published after 2000 and critically assess their strengths and limitations. Together with an overview of recent understanding, we highlight the need for a combined experimental and computational approach to study ion transport in solids of desired time and length scales and for precise measurements of physical parameters related to ion transport.