The kinetics of several fast heterogeneous electron-transfer reactions were investigated by steady-state voltammetry at nanoelectrodes and scanning electrochemical microscopy (SECM). The disk-type, polished Pt nanoelectrodes (3.7-400-nm radius) were characterized by a combination of voltammetry, scanning electron microscopy, and SECM. A number of experimental curves were obtained at the same nanoelectrode to attain the accuracy and reproducibility similar to those reported previously for micrometer-sized probes. A new analytical approximation was developed and used for analysis of steady-state tip voltammograms. The self-consistent kinetic parameter values with the uncertainty margin of approximately 10% were obtained for electrodes of different radii and for a wide range of the SECM tip/substrate separation distances. The determined standard rate constants are compared to those previously measured at the electrodes of different dimensions, and the correlation between the heterogeneous and self-exchange rate constants is discussed.

Broadband near-infrared (NIR)-emitting phosphors are key for next-generation smart NIR light sources based on blue LEDs. To achieve excellent NIR phosphors, we propose a strategy of enhancing the crystallinity, modifying the micromorphology, and maintaining the valence state of Cr3+ in Ca3Sc2Si3O12 garnet (CSSG). By adding fluxes and sintering in a reducing atmosphere, the internal quantum efficiency (IQE) is greatly enhanced to 92.3%. The optimized CSSG:6%Cr3+ exhibits excellent thermal stability. At 150 °C, 97.4% of the NIR emission at room temperature can be maintained. The fabricated NIR-LED device emits a high optical power of 109.9 mW at 520 mA. The performances of both the achieved phosphor and the NIR-LED are almost the best results until now. The mechanism for the optimization is investigated. An application of the NIR-LED light source is demonstrated.

The fundamentals of and recent advances in scanning electrochemical microscopy (SECM) are described. The focus is on applications of this method to studies of systems and processes of active current interest ranging from nanoelectrochemistry to electron transfer reactions and electrocatalysis to biological imaging.

Drawing a parallel: The phospholipid 1,2‐dioleoyl‐sn‐glycero‐3‐phosphocholine (DOPC) can be used as an ink for noncovalent patterning on a variety of surfaces under humidity‐controlled conditions. Simultaneous writing of different inks gives aligned, multilayer phospholipid patterns (see fluorescence image; scale bar=5 μm). These patterns are stable on some surfaces in water, while on others they can spread to form supported lipid bilayer membranes.