No abstract

No abstract

Today silicon carbide (SiC) Schottky diodes are mainly used in the power factor control (PFC) unit of high end switched mode power supplies, due to their outstanding switching performance compared to Si pn diodes. In the case of the PFC it is required that the diodes are capable of handling surge currents up to several times the current of normal operation. The paper shows the surge current capability of a merged pn Schottky diode where the p-areas are optimized as efficient emitters. During normal operation the diode is behaving like a normal Schottky diode whereas during surge current condition the diode is behaving like a pn diode. For a sine half wave of 10 ms we achieved a non repetitive peak forward current capability of about 3700 A/cm2 which is about ten times rated current (for comparison: destructive current density of a standard Schottky diode ~ 1650 A/cm²). Additionally the device shows a stable avalanche and is able to withstand a single shot avalanche of 9.5 3s and 12.5 mJ.

Today a main focus in high efficiency power electronics based on silicon carbide (SiC) lies on the development of an unipolar SiC switch. This paper comments on the advantages of SiC switching devices in comparison to silicon (Si) switches, the decision for the SiC JFET against the SiC MOSFET, and will show new experimental results on SiC JFETs with focus on the production related topics like process window and parameter homogeneity which can be achieved with the presented device concept. Due to material properties unipolar SiC switches have, other than their Si high voltage counterparts, very low gate charge, good body diode performance, and reduced switching losses because of the potential of lower in- and output capacitances. The most common unipolar switch is the MOSFET. However, the big challenge in the case of a SiC MOSFET is the gate oxide. A gate oxide on SiC that provides adequate performance and reliability is missing until now. An alternative unipolar switching device is a normally-on JFET. The normally-on behavior is a benefit for current driven applications. If a normally-off behavior is necessary the JFET can be used together with a low voltage Si MOSFET in a cascode arrangement. Recently manufactured SiC JFETs show results in very good accordance to device simulation and demonstrate the possibility to fabricate a SiC JFET within a mass production. A growing market opportunity for such a SiC switch becomes visible.