The structure of temperature-sensitive poly(N-isopropylacrylamide) microgels in dilute suspension was investigated by means of small-angle neutron scattering. A direct modeling expression for the scattering intensity distribution was derived which describes very well the experimental data at all temperatures over an extensive q range. The overall particle form as well as the internal structure of the microgel network is described by the model. The influence of temperature, cross-linking density, and particle size on the structure was revealed by radial density profiles and clearly showed that the segment density in the swollen state is not homogeneous, but gradually decays at the surface. The density profile reveals a box profile only when the particles are collapsed at elevated temperatures. An increase of the cross-linking density resulted in both an increase of the polymer volume fraction in the inner region of the particle and a reduction of the smearing of the surface. The polymer volume fraction inside the colloid decreased with increasing particle size. The structural changes are in good agreement with the kinetics of the emulsion copolymerization used to prepare the microgel colloids.

The shear orientation of the hexagonal liquid crystal phase of nonionic surfactant/water mixtures was investigated by means of different techniques, namely, microscopy, small-angle light and neutron scattering, (SALS, SANS), birefringence, and nuclear magnetic resonance (NMR). On a microscopic length scale probed by NMR, SANS, and birefringence, the shear flow results in an alignment of rodlike micelles along the flow direction. The 10 plane was parallel to the shear plane. On a mesoscopic length scale, studied by microscopy and SALS, a stripe texture was observed. This is due to an undulation of the director which is on average aligned in flow direction. The corresponding SALS pattern shows a better orientation correlation perpendicular to the flow direction.

The structure of concentrated temperature-sensitive poly(N-isopropylacrylamide) (PNiPAM) microgel suspensions has been investigated employing rheology and small-angle neutron scattering (SANS). A previously described model expression for the particle form factor P(inho)(q) is extended by a model hard sphere structure factor S(q), and the average radial density profiles phi(r) are calculated from the amplitude of the form factor A(q) and the structure factor S(q). By this procedure, a direct real space description of the spatial ordering in the neighborhood of a single particle is obtained. The overall particle size and the correlation length xi of the concentration fluctuations of the internal polymer network decrease with concentration, revealing the increasing compression of the spheres. Thus, the particle form factor P(inho)(q) of the swollen PNiPAM microgels depends on concentration. The particle-particle interaction potential does not change significantly between 25 and 32 degrees C. Even approximately 1 K below the lower critical solution temperature (LCST), the experimental scattering intensity distributions I(q)/c are described very well by the hard sphere structure factor when an equivalent hard sphere particle size R(HS) and volume fraction eta(HS) are used. Microgels with different degrees of cross-linking and particle size resemble true hard sphere behavior up to effective volume fractions of phi(eff) < 0.35. At higher effective volume fractions phi(eff) > 0.35 strong deviations from true hard spheres are observed. Interpenetration of the outer, less cross-linked regions of the soft spheres as well as particle compression occurred at higher concentrations. In agreement with this, the equilibrium colloidal phase behavior and rheology also has some features of soft sphere systems. At temperatures well above the LCST, the interaction potential becomes strongly attractive and the collapsed microgel spheres form aggregates consisting of flocculated particles without significant long-range order. Hence, an attractive interaction potential in concentrated suspensions of PNiPAM microgels leads to distinctively different structures as compared to attractive hard sphere colloids. When the peculiar structural properties of the PNiPAM microgels are considered, they can be used as model systems in colloidal science.