Safety is one of the key aspects of the successful transport of cargo. In the case of road transport, the dynamics of a vehicle during normal events such as braking, steering, and evasive maneuver are variable in different places in the vehicle. Several manufacturers provide different dataloggers with acceleration sensors, but the results are not comparable due to different sensor parameters, measurement ranges, sampling frequencies, data filtration, and evaluation of different periods of acceleration. The position of the sensor in the loading area is also important. The accelerations are not the same at all points in the vehicle. The article deals with the measurement of these dynamic events with MEMS sensors on selected points of a vehicle loaded with cargo and with changes in dynamics after certain events that could occur during regular road transport of cargo to analyze the possibilities for monitoring accelerations and the related forces acting on the cargo during transport. The article uses evaluation times of 80, 300, and 1000 ms for accelerations. With the measured values, it is possible to determine the places with a higher risk of cargo damage and not only to adjust the packaging and securing of the cargo, but also to modify the transport routes. Concerning the purposes of securing the cargo in relation to EN 12195-1 and the minimum values of forces for securing the cargo, we focused primarily on the places where the acceleration of 0.5 g was exceeded when analyzing the monitored route. There were 32 of these points in total, all of which were measured by a sensor located at the rear of the semi-trailer. In 31 cases, the limit of 0.5 g was exceeded for an 80-ms evaluation time, and in one case, the value of 0.51 g was reached in the transverse direction for a 300-ms evaluation time.

No abstract

No abstract

No abstract

The development of an economy and, in particular, the construction of new infrastructure as well as industrial enterprises creates demand for the road transport of oversized freight that exceeds the maximum permissible total mass of vehicle combinations with its share on the axles. Failure to comply with the defined technological processes and a deficiency in the assessment of permitting such forms of transportation can have a large adverse effect, predominantly on the lifetime of bridges in a road network, which can have international implications as well. There is no legislation adopted by the EU Member States, which would at least partially unify the authorisation procedures of these forms of transportation and, therefore, it results in problems when crossing borders and leads to differences related to the assessment of bridge passages. If there is no systematic inspection of this kind of transportation, it can lead to permanent damage of these bridges as well. Currently, and not only in Slovakia but also in other states, the assessment of bridge passage for certain routes is used for heavy and oversized transportation. It means that if we use 100 transports, 100 assessments of individual routes are needed, although some are the same routes or the same vehicles/vehicle combinations used for a number of transports. Thus, the authors designed a global assessment for bridge passage in relation to heavy and oversized road transport while verifying it in the conditions of the EU Member State from Central Europe–Slovakia. Roads are full of different types of vehicles/vehicle combinations for which the axle loads and distances of the axles (wheelbases) are important. Thus, there were vehicle/vehicle combinations parameters (big data) observed, for which the routes relating to heavy and/or oversized transportation were assessed from 1 January 2016 to 31 December 2020 in Slovakia. The global assessment of bridge passage introduces an entirely new approach within the procedure for obtaining a special permission for road use as well as within transport use itself. Given the low presence of freight with an abnormal axle load or enormous total mass, it is appropriate to define the limited conditions under which it would be possible to implement the global assessment in practice as well.