International audienceThis paper presents the results of an experimental study concerning the incorporation of polyurethane (PUR) foam wastes into cementitious mixtures in order to produce lightweight concrete. A semi-empirical method is first proposed to predict the density of fresh PUR foam-based concrete mixtures. Seven concrete mixtures containing various PUR foam volume fractions (from 13.1% to 33.7%), and two reference concrete mixtures (without PUR foam) were prepared and characterized. In particular, their thermal and mechanical properties were determined. This permitted to quantify the influence of the PUR foam volume fraction on these parameters. Some specimens were maintained under water during 28 days, while the others were dried in air. The PUR-foam concrete thermal conductivity and compressive strength are, respectively, 2–7 times and 2–17 times lower than those of the reference mixture, depending on the volume fraction of PUR foam and on the curing conditions. Besides, the use of PUR foam in concrete implies a strong increase in the drying shrinkage and in the mass loss during the first seven days. These results can be related to the high porosity and the weak compressive strength of alveolar polyurethane

International audienceSelf-compacting concrete (SCC) mixtures are usually designed with higher volumes of paste than vibrated concrete mixtures. The results reported in this paper come from a study of nine SCC concrete mixtures. Volume of paste was varied between 291 and 457 l/m3. One of the mixtures had already been used in a large scale test, and the others were designed by varying several parameters of the reference concrete mixture. Mechanical properties, shrinkage, fracture parameters and fracture process zone (FPZ) size were measured. Fracture behavior was characterized by means of three-point bending tests and acoustic emission analysis. From the experimental results, increasing the volume of paste has a restricted effect on strength, unless water content varies. Strength, elastic modulus and fracture resistance slightly decrease with an increase in paste content. Volume of paste causes an increase in shrinkage and cracking due to shrinkage. Fracture and acoustic emission analysis show that increasing the volume of paste tends to make SCC more brittle

This article presents a study on the influence of limestone filler and granular inclusions on the chemical shrinkage of cementitious matrices at very early age (624 h). Measurements of chemical shrinkage and hydration degree are carried out on cement pastes and mortars. During this study, two cement types (CEM 1 and CEM 2), two water-to-cement ratios (W/C = 0.30 and 0.40) and three substitution rates of cement by limestone filler (LF/C = 0; 0.25 and 0.67) are used. The effects of aggregate shape (glass beads and natural sand), aggregate-to-cement mass ratio (A/C = 0.5 and 1) and particle size distribution (D = 1 and 2 mm) on the chemical shrinkage and the hydration rate are quantified. The results obtained show that limestone filler causes an acceleration of both Le Chatelier's contraction and hydration process since the very first hours of hydration. In addition, the chemical shrinkage amplitude is not significantly influenced by the presence of aggregates. Finally, the presence of limestone filler and granular inclusions does not cause significant modification of the quasi-linear relation observed at early age between the chemical shrinkage and the hydration degree of the cementitious matrices.

No abstract