Rubber nanocomposites based on natural rubber (NR)-butadiene nitrile rubber (NBR) blend filled with silane modified nanosilica (NSBT) and carbon black (CB) were prepared by melt mixing method by using an internal mixer. The effect of CB and NSBT on thermo-mechanical properties of the materials was investigated by scanning electron microscopy (SEM), thermogravimetric analysis (TGA), dynamic-mechanical analysis (DMA) and tensile testing method. The results show that the NR/NBR blends reinforced with both CB and NSBT possess the properties much better than that reinforced with only CB or NSBT. With the CB/NSBT ratio of 25/5, the properties of the NR/NBR blends were remarkably enhanced, especially the increase in tensile strength by about 64 % and the increase in the thermal stability by about 13 o C. The reasons for the improvement of NR/NBR blends' properties are due to better compatibility of the components in the rubber blend as well as the better compactness in their structure with the presence of NSBT.

In this work, rubber nanocomposites based on natural rubber/ethylene propylene diene monomer (NR/EPDM) blends and reinforced with nanosilica (NS) in combination with carbon black (CB) and barium sulfate (BS) were prepared by melt blending method in a Brabender internal mixer. The appropriate contents of NS and CB for reinforcing the rubber nanocomposites based on NR/EPDM are 10 and 30 phr (parts per hundred rubber), respectively. The NR/EPDM nanocomposites material reinforced with 10 phr NS and 30 phr CB has the best mechanical properties that with the enhancement of tensile strength over 117% and 40 % compared to that of the NR/EPDM nanocomposite material unreinforced and reinforced with only 10 phr NS, respectively. The appropriate content of BS for replacement of CB in the NR/EPDM blend is 6 phr. The rubber nanocomposite based on NR/EPDM (60/40) blend reinforced with 10 phr NS, 24 phr CB and 6 phr BS has a tight structure, high mechanical properties, and especially, high alkali resistance and heat resistance, abrasion resistance and low endogenous heat due to rotation and friction. This material may be used to manufacture technical rubber products that require heat resistance and stability in alkaline environments, such as conveyor belts used in the cement industry.