Virtually every video watermarking technology can benefit from comparison with the original content. For non-blind schemes it is fundamental; for others it is an improvement to increase the watermark's signal-to-noise ratio by subtracting the content that is often noise to the detector. A direct frame-by-frame comparison of the videos is not possible due to the fact that illegal copies of videos usually differ significantly from their originals caused by different spatial resolution or frame rates, geometric distortions from capturing, or targeted attacks. In this paper, we present a software tool that enables the semi-automatic temporal and spatial synchronization of frames and pixels of two similar videos. This process is called registration. We put our focus on utilizing human capabilities with the smallest possible effort, to allow a high overall performance and precision of the registration. An efficient graphical user interface supports the users and visualizes the results of all steps. In addition, we specifically distinguish digitally reproduced copies from analog (camcorded) copies in which two or more frames are blended into a new frame.

ObjectivesDosimetric control of staff exposure during interventional procedures under fluoroscopy is of high relevance. In this paper, a novel ray casting approximation of radiation transport is presented and the potential and limitation vs. a full Monte Carlo transport and dose measurements are discussed.MethodThe x‐ray source of a Siemens Axiom Artix C‐arm is modeled by a virtual source model using single Gaussian‐shaped source. A Geant4‐based Monte Carlo simulation determines the radiation transport from the source to compute scatter from the patient, the table, the ceiling and the floor. A phase space around these scatterers stores all photon information. Only those photons are traced that hit a surface of phantom that represents medical staff in the treatment room, no indirect scattering is considered; and a complete dose deposition on the surface is calculated. To evaluate the accuracy of the approximation, both experimental measurements using Thermoluminescent dosimeters (TLDs) and a Geant4‐based Monte Carlo simulation of dose depositing for different tube angulations of the C‐arm from cranial‐caudal angle 0° and from LAO (Left Anterior Oblique) 0°–90° are realized. Since the measurements were performed on both sides of the table, using the symmetry of the setup, RAO (Right Anterior Oblique) measurements were not necessary.ResultsThe Geant4‐Monte Carlo simulation agreed within 3% with the measured data, which is within the accuracy of measurement and simulation. The ray casting approximation has been compared to TLD measurements and the achieved percentage difference was −7% for data from tube angulations 45°–90° and −29% from tube angulations 0°–45° on the side of the x‐ray source, whereas on the opposite side of the x‐ray source, the difference was −83.8% and −75%, respectively. Ray casting approximation for only LAO 90° was compared to a Monte Carlo simulation, where the percentage differences were between 0.5–3% on the side of the x‐ray source where the highest dose usually detected was mainly from primary scattering (photons), whereas percentage differences between 2.8–20% are found on the side opposite to the x‐ray source, where the lowest doses were detected. Dose calculation time of our approach was 0.85 seconds.ConclusionThe proposed approach yields a fast scatter dose estimation where we could run the Monte Carlo simulation only once for each x‐ray tube angulation to get the Phase Space Files (PSF) for being used later by our ray casting approach to calculate the dose from only photons which will hit an movable elliptical cylinder shaped phantom and getting an output file for the positions of those hits to be used for visualizing the scatter dose propagation on the phantom surface. With dose calculation times of less than one second, we are saving much time compared to using a Monte Carlo simulation instead. With our approach, larger deviations occur only in regions with very low doses, whereas it provides a high precision in high‐dose regions.

No abstract

To support the development of any system that includes the generation and evaluation of camcorder copies, as well as to provide a common benchmark for robustness against camcorder copies, we present a tool to simulate digital video re-acquisition using a digital video camera. By resampling each video frame, we simulate the typical artifacts occurring in a camcorder copy: geometric modifications (aspect ratio changes, cropping, perspective and lens distortion), temporal sampling artifacts (due to different frame rates, shutter speeds, rolling shutters, or playback), spatial and color subsampling (rescaling, filtering, Bayer color filter array), and processing steps (automatic gain control, automatic white balance). We also support the simulation of camera movement (e.g., a hand-held camera) and background insertion. Furthermore, we allow for an easy setup and calibration of all the simulated artifacts, using sample/reference pairs of images and videos. Specifically temporal subsampling effects are analyzed in detail to create realistic frame blending artifacts in the simulated copies. We carefully evaluated our entire camcorder simulation system and found that the models we developed describe and match the real artifacts quite well.

In the efforts to fight piracy of high-valued media content, forensic digital watermarking as a passive content security scheme is a potential alternative to current, restrictive approaches like DRM. In this paper, we present a novel watermarking scheme for videos based on affine geometric transformations. Frames can be modified in an imperceptible manner by applying a small, global rotation, translation, or zooming, which can be detected later on by comparison with the originals. To compensate geometric distortions that have been introduced while a video travels down legal as well as illegal distribution chains, a spatio-temporal synchronization is performed using our video registration toolkit application. To evaluate our approach, we compare it with several other schemes regarding the robustness against common attacks, including camcorder capture.