Recent advances in the controlled RAFT polymerization of complex macromolecular architectures based on poly(N-vinyl pyrrolidone), PNVP, are summarized in this review article. Special interest is given to the synthesis of statistical copolymers, block copolymers, and star polymers and copolymers, along with graft copolymers and more complex architectures. In all cases, PNVP is produced via RAFT techniques, whereas other polymerization methods can be employed in combination with RAFT to provide the desired final products. The advantages and limitations of the synthetic methodologies are discussed in detail.

The synthesis of statistical copolymers of N-vinylpyrrolidone (NVP) with isobornyl methacrylate (IBMA) was conducted by free radical and reversible addition-fragmentation chain transfer (RAFT) polymerization. The reactivity ratios were estimated using the Finemann-Ross, inverted Fineman-Ross, Kelen-Tüdos, extended Kelen-Tüdos and Barson-Fenn graphical methods, along with the computer program COPOINT, modified to both the terminal and the penultimate models. According to COPOINT the reactivity ratios were found to be equal to 0.292 for NVP and 2.673 for IBMA for conventional radical polymerization, whereas for RAFT polymerization and for the penultimate model the following reactivity ratios were obtained: r11 = 4.466, r22 = 0, r21 = 14.830, and r12 = 0 (1 stands for NVP and 2 for IBMA). In all cases, the NVP reactivity ratio was significantly lower than that of IBMA. Structural parameters of the copolymers were obtained by calculating the dyad sequence fractions and the mean sequence length. The thermal properties of the copolymers were studied by differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), and differential thermogravimetry (DTG). The results were compared with those of the respective homopolymers.

Τhis work describes the synthesis of PLA-grafted M-alginate (g-M-alginate; M: Ca2+, Co2+, Ni2+, Cu2+) aerogels. DL-lactide (LA) was attached on the surface of preformed M-alginate beads and was polymerized, using stannous octoate as catalyst and the –OH groups of the alginate backbone as initiators/points of attachment. The material properties of g-M-alginate aerogels were not affected much by grafting, because the linear PLA chains grew on the M-alginate framework like a brush and did not bridge their points of attachment as in polyurea-crosslinked M-alginate aerogels. Thus, all g-M-alginate aerogels retained the fibrous morphology of their parent M-alginate aerogels, and they were lightweight (bulk densities up to 0.24 g cm−3), macroporous/mesoporous materials with high porosities (up to 96% v/v). The BET surface areas were in the range of 154–542 m2 g−1, depending on the metal, the nature of the alginate framework and the PLA content. The latter was found at about 15% w/w for Ca- and Ni-based materials and at about 29% w/w for Co- and Cu-based materials. Overall, we have demonstrated a new methodology for the functionalization of alginate aerogels that opens the way to the synthesis of polylactide-crosslinked alginate aerogels with the use of multifunctional monomers.