This paper presents an original characterization method of trapping phenomena in gallium nitride high electron mobility transistors (GaN HEMTs). This method is based on the frequency dispersion of the output-admittance that is characterized by low-frequency S-parameter measurements. As microwave performances of GaN HEMTs are significantly affected by trapping effects, trap characterization is essential for this power technology. The proposed measurement setup and the trap characterization method allow us to determine the activation energy Ea and the capture cross-section σnof the identified traps. Three original characterizations are presented here to investigate the particular effects of bias, ageing, and light, respectively. These measurements are illustrated through different technologies such as AlGaN/GaN and InAlN/GaN HEMTs with non-intentionally doped or carbon doped GaN buffer layers. The extracted trap signatures are intended to provide an efficient feedback to the technology developments

We describe the development of cross-correlation based high resolution electron backscatter diffraction (HR-EBSD) and electron channelling contrast imaging (ECCI), in the scanning electron microscope (SEM), to quantitatively map the strain variation and lattice rotation and determine the density and identify dislocations in nitride semiconductor thin films. These techniques can provide quantitative, rapid, non-destructive analysis of the structural properties of materials with a spatial resolution of order of tens of nanometers. HR-EBSD has a sensitivity to changes of strain and rotation of the order of 10−4 and 0.01° respectively, while ECCI can be used to image single dislocations up to a dislocation density of order 1010 cm−2. In the present work, we report the application of the cross-correlation based HR-EBSD approach to determine the tilt, twist, elastic strain and the distribution and type of threading dislocations in InAlN/AlN/GaN high electron mobility transistor (HEMT) structures grown on two different substrates, namely SiC and sapphire. We describe our procedure to estimate the distribution of geometrically necessary dislocations (GND) based on Nye-Kroner analysis and compare them with the direct imaging of threading dislocations (TDs) by ECCI. Combining data from HR-EBSD and ECCI observations allowed the densities of pure edge, mixed and pure screw threading dislocations to be fully separated

The surface chemistry of InAlN ultra-thin layers, having undergone an oxidation procedure usually running through the HEMT fabrication process (850 • C, O 2 and O 2 +Ar) is studied by XPS. The suitability of XPS analysis to operate as a retro-engineering tool for added value microelectronic devices fabrication is shown. A precise examination of the Al2p, In3d 5/2 , N1s, and O1s peaks directly informs about spatial and atomic arrangement. The formation of a covering 3 nm surface oxide is evidenced after O 2 annealing. Once annealed, two specific additional N1s contributions are shown, at higher (404.0 eV) and lower binding energies (397.4 eV) compared to the InAlN matrix one (396.5 eV). To our knowledge, such fingerprint is rather unusual for ternary III-V materials. It reveals the formation of a nitrogen deficient interlayer, situated between the oxide overlayer and the undisturbed matrix, and the presence of interstitial N 2 molecules trapped at the interface. After Ar annealing, both oxide and interface layers are partially reorganized. InAlN reactivity toward higher annealing temperature (950 • C) and its stability over time is finally discussed. N 2 molecules are unstable and progressively eliminated in time although nitrogen deficient interlayer still remains. Thermal treatments below 850 • C are recommended to preserve the barrier chemical integrity.

No abstract