The aim of this work is to present the use of proper orthogonal decomposition (POD) and extended proper orthogonal decomposition (EPOD) for revealing flame dynamics as a set of statistical quantities referred as modes. The flame fluctuations are used to derive an empirical functions base representing the most important features of the flame. The capabilities of the technique are exemplified in the case of an unsteady laminar flame. The flame is naturally unsteady and can be excited to amplify the fluctuations. The data base consists of synchronous Particle Image Velocimetry (PIV) and OH-Planar Laser Induced Fluorescence (OH-PLIF) measurements. It was found that the POD based upon the PIV vectors only reveals flow features when the excitation is added. On contrary, the OH-PLIF based POD performs well in any case and constitutes a suitable base for the EPOD analysis.

The effect of axial forcing on the flame/vortex breakdown interaction is studied, with particular focus on the Precessing Vortex Core (PVC). Large Eddy Simulation (LES), together with a filtered flamelet model describing the subgrid combustion, is performed to study a lean premixed flame undergoing mass flow fluctuations in a wide range of frequencies and amplitude. In average, forcing at frequencies lower than the PVC characteristic frequency moves the recirculation zone upstream the combustor in the premixing tube, while higher frequencies do not relevantly affect the flow/flame. With the help of Proper Orthogonal Decomposition (POD) a detailed analysis of the dynamics of the central recirculation zone (CRZ) is performed showing how the excitation at lower frequencies weakens the PVC and allows the flame to propagate upstream. Extended POD is also applied to illustrate the flow/flame interactions during the excitation cycle.

No abstract

No abstract

The most recent development in centrifugal compressor technology is towards wet gas operating conditions. This means the centrifugal compressor has to manage a liquid phase which is varying between 0 to 3% Liquid Volume Fraction (LVF) according to the most widely agreed definition. The centrifugal compressor operation is challenged by the liquid presence with respect to all the main aspects (e.g. thermodynamics, material selection, thrust load) and especially from a rotordynamic viewpoint. The main test results of a centrifugal compressor tested in a special wet gas loop [1] show that wet gas compression (without an upstream separation) is a viable technology. In wet gas conditions the rotordynamic behavior could be impacted by the liquid presence both from a critical speed viewpoint and stability wise. Moreover the major rotordynamic results from the previous mentioned test campaign [2] show that both vibrations when crossing the rotor first critical speed and stability (tested through a magnetic exciter) are not critically affected by the liquid phase. Additionally it was found that the liquid may affect the vibration behavior by partially flooding the internal annular seals and causing a sort of forced excitation phenomenon. In order to better understand the wet gas test outcomes, the authors performed an extensive CFD analysis simulating all the different types of balance piston annular seals used (namely a Tooth on Stator Labyrinth Seal and a Pocket Damper Seal). They were simulated in both steady state and transient conditions and finally compared in terms of liquid management capability. CFD simulation after a proper tuning (especially in terms of LVF level) showed interesting results which are mostly consistent with the experimental outcome. The results also provide a physical explanation of the behavior of both seals, which was observed during testing.