The surface properties of polyethylene can successfully be altered using argon plasmas. In this work, the surface modification of low density polyethylene (LDPE) using an argon atmospheric pressure plasma jet (APPJ) is profoundly investigated. The surface modification is examined using different analysing techniques namely, water contact angle (WCA) measurements for the wettability and X-ray photoelectron spectroscopy (XPS) for the chemical composition. Particular attention is paid to the treatment distance between the plasma jet capillary and the LDPE foil and the applied treatment time. At treatment distances between 5 and 15 mm, the WCA can be reduced with more than 70% within a treatment time of a few ms. XPS measurements reveal that this is due to the incorporation of oxygen containing groups and especially the increased implementation of the O-C=O group has a big influence. At treatment distances above 15 mm, the wettability decreases with increasing treatment distance. The wettability can however be enhanced by increasing the treatment time. Ageing considerations show that the loss in treatment efficiency is restricted to only 25%, meaning that even after 14 days of ageing the WCA reduction upon plasma treatment is still more than 40%. Based on the above mentioned results, the most appropriate parameters can thus be selected to provide an efficient plasma treatment of LDPE using the argon APPJ.3

No abstract

No abstract

An antimicrobial nano-silver non-woven polyethylene terephthalate (PET) fabric has been prepared in a three step process. The fabrics were first pretreated by depositing a layer of organosilicon thin film using an atmospheric pressure plasma system, then silver nano-particles (AgNPs) were incorporated into the fabrics by a dipping-dry process, and finally the nano-particles were covered by a second organosilicon layer of 10-50 nm, which acts as a barrier layer. Different surface characterization techniques like SEM and XPS have been implemented to study the morphology and the chemical composition of the nano-silver fabrics. Based on these techniques, a uniform immobilization of AgNPs in the PET matrix has been observed. The antimicrobial activity of the treated fabrics has also been tested using P. aeruginosa, S. aureus and C. albicans. It reveals that the thickness of the barrier layer has a strong effect on the bacterial reduction of the fabrics. The durability and stability of the AgNPs on the fabrics has also been investigated in a washing process. By doing so, it is confirmed that the barrier layer can effectively prevent the release of AgNPs and that the thickness of the barrier layer is an important parameter to control the silver ions release.

This paper provides a comprehensive overview of nanofibrous structures for tissue engineering purposes and the role of non-thermal plasma technology (NTP) within this field. Special attention is first given to nanofiber fabrication strategies, including thermally-induced phase separation, molecular self-assembly, and electrospinning, highlighting their strengths, weaknesses, and potentials. The review then continues to discuss the biodegradable polyesters typically employed for nanofiber fabrication, while the primary focus lies on their applicability and limitations. From thereon, the reader is introduced to the concept of NTP and its application in plasma-assisted surface modification of nanofibrous scaffolds. The final part of the review discusses the available literature on NTP-modified nanofibers looking at the impact of plasma activation and polymerization treatments on nanofiber wettability, surface chemistry, cell adhesion/proliferation and protein grafting. As such, this review provides a complete introduction into NTP-modified nanofibers, while aiming to address the current unexplored potentials left within the field.