Abstract. Recent tests of a single module of the Jagiellonian Positron Emission Tomography system (J-PET) consisting of 30 cm long plastic scintillator strips have proven its applicability for the detection of annihilation quanta (0.511 MeV) with a coincidence resolving time (CRT) of 0.266 ns. The achieved resolution is almost by a factor of two better with respect to the current TOF-PET detectors and it can still be improved since, as it is shown in this article, the intrinsic limit of time resolution for the determination of time of the interaction of 0.511 MeV gamma quanta in plastic scintillators is much lower. As the major point of the article, a method allowing to record timestamps of several photons, at two ends of the scintillator strip, by means of matrix of silicon photomultipliers (SiPM) is introduced. As a result of simulations, conducted with the number of SiPM varying from 4 to 42, it is shown that the improvement of timing resolution saturates with the growing number of photomultipliers, and that the 2 x 5 configuration at two ends allowing to read twenty timestamps, constitutes an optimal solution. The conducted simulations accounted for the emission time distribution, photon transport and absorption inside the scintillator, as well as quantum efficiency and transit time spread of photosensors, and were checked based on the experimental results. Application of the 2 x 5 matrix of SiPM allows for achieving the coincidence resolving time in positron emission tomography of ≈ 0.170 ns for 15 cm axial field-of-view (AFOV) and ≈ 0.365 ns for 100 cm AFOV. The results open perspectives for construction of a cost-effective TOF-PET scanner with significantly better TOF resolution and larger AFOV with respect to the current

Within gauge/gravity duality, we consider the local quench-like time evolution obtained by joining two 1+1-dimensional heat baths at different temperatures at time t = 0. A steady state forms and expands in space. For the 2+1-dimensional gravity dual, we find that the "shockwaves" expanding the steady-state region are of spacelike nature in the bulk despite being null at the boundary. However, they do not transport information. Moreover, by adapting the time-dependent Hubeny-Rangamani-Takayanagi prescription, we holographically calculate the entanglement entropy and also the mutual information for different entangling regions. For general temperatures, we find that the entanglement entropy increase rate satisfies the same bound as in the 'entanglement tsunami' setups. For small temperatures of the two baths, we derive an analytical formula for the time dependence of the entanglement entropy. This replaces the entanglement tsunami-like behaviour seen for high temperatures. Finally, we check that strong subadditivity holds in this time-dependent system, as well as further more general entanglement inequalities for five or more regions recently derived for the static case.

Motivated by experiments on a hydrodynamic regime in electron transport, we study the effect of an oscillating electric field in such a setting. We consider a long two-dimensional channel of width L, whose geometrical simplicity allows an analytical study as well as hopefully permitting experimental realisation. The response depends on viscosity ν, driving frequency, ω and ohmic heating coefficient γ via the dimensionless complex variable L 2 ν (iω + γ) = iΩ + Σ. While at small Ω, we recover the static solution, a new regime appears at large Ω with the emergence of a boundary layer. This includes a splitting of the location of maximal flow velocity from the centre towards the edges of the boundary layer, an an increasingly reactive nature of the response, with the phase shift of the response varying across the channel. The scaling of the total optical conductance with L differs between the two regimes, while its frequency dependence resembles a Drude form throughout, even in the complete absence of ohmic heating, against which, at the same time, our results are stable. Current estimates for transport coefficients in graphene and delafossites suggest that the boundary layer regime should be experimentally accessible.

We analyze the role of boundary geometry in viscous electronic hydrodynamics. We address the twin questions of how boundary geometry impacts flow profiles, and how one can engineer boundary conditions -in particular the effective slip parameter -to manipulate the flow in a controlled way. We first propose a micropatterned geometry involving finned barriers, for which we show by an explicit solution that one can obtain effectively no-slip boundary conditions regardless of the detailed microscopic nature of the channel surface. Next we analyse the role of mesoscopic boundary curvature on the effective slip length, in particular its impact on the Gurzhi effect. Finally we investigate a hydrodynamic flow through a circular junction, providing a solution, which suggests an experimental set-up for determining the slip parameter. We find that its transport properties differ qualitatively from the case of ballistic conduction, and thus presents a promising setting for distinguishing the two.