An air-breathing direct formic acid microfluidic fuel cell, which had a self-made anode electrode of 10 mg/cm 2 Pd loading and 6 mg/cm 2 Nafion content, was fabricated and tested. The microfluidic fuel cell was achieved by bonding a PDMS microchannel that was fabricated by a soft-lithography process and a PMMA sheet that was machined by a CO2 laser for obtaining 50 through holes of 0.5 mm in diameter. Formic acid of 0.3 M, 0.5 M, and 1.0 M, mixed with 0.5-M H2SO4, was supplied at a flow rate ranging from 0.1 to 0.7 mL/min as fuel. The maximum power density of the fuel cell fed with 0.5-M HCOOH was approximately 31, 32.16, and 31 mW/cm 2 at 0.5, 0.6, and 0.7 mL/min, respectively. The simultaneous recording of the flow in the microchannel and the current density of the fuel cell at 0.2 V, within a 100-s duration, showed that the period and amplitude of each unsteady current OPEN ACCESSEnergies 2015, 8 2083 oscillation were associated with the bubble resident time and bubble dimension, respectively. The effect of bubble dimension included the longitudinal and transverse bubble dimension, and the distance between two in-line bubbles as well.