Water drops moving on surfaces are not only an everyday phenomenon seen on windows but also form an essential part of many industrial processes. Previous understanding is that drop motion is dictated by viscous dissipation and activated dynamics at the contact line. Here we demonstrate that these two effects cannot fully explain the complex paths of sliding or impacting drops. To accurately determine the forces experienced by moving drops, we imaged their trajectory when sliding down a tilted surface, and applied the relevant equations of motion. We found that drop motion on low-permittivity substrates is substantially influenced by electrostatic forces. Our findings confirm that electrostatics must be taken into consideration for the description of the motion of water, aqueous electrolytes and ethylene glycol on hydrophobic surfaces. Our results are relevant for improving the control of drop motion in many applications, including printing, microfluidics, water management and triboelectric nanogenerators.

When a water drop slides over a hydrophobic surface, it usually acquires a positive charge and deposits the negative countercharge on the surface. Although the electrification of solid surfaces induced after contact with a liquid is intensively studied, the actual mechanisms of charge separation, so-termed slide electrification, are still unclear. Here, slide electrification is studied by measuring the charge of a series of water drops sliding down inclined glass plates. The glass was coated with hydrophobic (hydrocarbon/fluorocarbon) and amine-terminated silanes. On hydrophobic surfaces, drops charge positively while the surfaces charge negatively. Hydrophobic surfaces coated with a mono-amine (3-aminopropyltriethyoxysilane) lead to negatively charged drops and positively charged surfaces. When coated with a multiamine ( N -(3-trimethoxysilylpropyl)diethylenetriamine), a gradual transition from positively to negatively charged drops is observed. We attribute this tunable drop charging to surface-directed ion transfer. Some of the protons accepted by the amine-functionalized surfaces (−NH 2 with H + acceptor) remain on the surface even after drop departure. These findings demonstrate the facile tunability of surface-controlled slide electrification.

The charge state of dielectric surfaces in aqueous environments is of fundamental and technological importance. Here, we study the influence of dissolved molecular CO2 on the charging of three chemically different surfaces (SiO2, Polystyrene, Perfluorooctadecyltrichlorosilane). We determine their charge state from electrokinetic experiments. We compare an ideal, CO2-free reference system to a system equilibrated against ambient CO2 conditions. In the reference system, the salt-dependent decrease of the magnitudes of ζ-potentials follows the expectations for a constant charge scenario. In the presence of CO2, the starting potential is lower by some 50%. The following salt-dependent decrease is weakened for SiO2 and inverted for the organic surfaces. We show that screening and pH-driven charge regulation alone cannot explain the observed effects. As an additional cause, we tentatively suggest dielectric regulation of surface charges due to a diffusively adsorbed thin layer of molecular CO2. The formation of such a dynamic layer, even at the hydrophilic and partially ionized silica surfaces, is supported by a minimal theoretical model and results from molecular simulations.

When neutral water drops impact and rebound from superhydrophobic surfaces, they acquire a positive electrical charge. To measure the charge, we analyzed the trajectory of rebounding drops in an external...

When a drop of a polar liquid slides over a hydrophobic surface, it acquires a charge. As a result, the surface charges oppositely. For applications such as the generation of electric energy, lubricant-infused surfaces (LIS) may be important because they show a low friction for drops. However, slide electrification on LIS has not been studied yet. Here, slide electrification on lubricant-infused surfaces was studied by measuring the charge generated by series of water drops sliding down inclined surfaces. As LIS, we used PDMS-coated glass with micrometer-thick silicone oil films on top. For PDMS-coated glass without lubricant, the charge for the first drop is highest. Then it decreases and saturates at a steady state charge per drop. With lubricant, the drop charge starts from 0, then it increases and reaches a maximum charge per drop. Afterward, it decreases again before reaching its steady-state value. This dependency is not a unique phenomenon for lubricant-infused PDMS; it also occurs on lubricant-infused micropillar surfaces. We attribute this dependency of charge on drop numbers to a change in surface conductivity and depletion of lubricant. These findings are helpful for understanding the charge process and optimizing solid–liquid nanogenerator devices in applications.