Maximum power extraction from the photovoltaic (PV) system plays a critical role in increasing efficiency during partial shading conditions (PSC's). The higher cost and low conversion efficiency of the PV panel necessitate the extraction of the maximum power point (MPP). So, a suitable maximum power point tracking (MPPT) technique to track the MPP is of high need, even under PSC's. This study gives an extensive review of 23 MPPT techniques present in literature along with recent publications on various hardware design methodologies. MPPT classification is done into three categories, i.e. Classical, Intelligent and Optimisation depending on the tracking algorithm utilised. During uniform insolation, classical methods are highly preferred as there is only one peak in the P-V curve. However, under PSC's, the P-V curve exhibits multiple peaks, one global MPP (GMPP) and the remaining are local MPPs. Hence, Intelligent and Optimisation techniques came into limelight to differentiate the GMPP out of all LMPPs. Every MPPT technique has its advantages and limits, but a streamlined MPPT is drafted in numerous parameters like sensors required, hardware implementation, tracking in PSC's, cost, tracking speed and tracking efficiency. This present study aimed to address the advancement in this area for further research. Nomenclature C dc DC link capacitor V mpp voltage at maximum power point I mpp current at maximum power point P mpp power at maximum power point P-V curve power-voltage curve I-V curve current-voltage curve V oc PV open circuit voltage I sc PV short circuit current

No abstract

No abstract

No abstract

At present, primary power generation depends on non-renewable energy resources, which will become extinct. Solar is the best option in renewable energy sources to achieve clean and green power extraction. Solar PV transforms light energy into electrical energy. However, the output power of solar PV changes with solar insolation. It is also affected by environmental factors and the shading effect. One of the key factors that can reduce the PV system output power is partial shading condition (PSC). The reduction in power output not only depends on shaded region but also depends on pattern of shading and physical position of shaded modules in the array. Due to PSCs, mismatch losses are induced between the shaded modules which can cause several peaks in the output power–voltage (P-V) characteristic. This article describes the non-symmetrical reconfiguration technique and compares it with the primary total cross tied connection. The performance of non-symmetrical reconfiguration techniques is evaluated and compared in terms of global maximum power (GMP), voltage and currents at GMP, open and short circuit voltage and currents, mismatch power loss (MPL), fill factor, efficiency, and number of local maximum power peaks (LMPPs) on a 9 × 9 PV array.