An experimental study of mini-jet impingement boiling is presented for saturated conditions. Unique to this study is documentation of boiling characteristics of a submerged water jet under sub-atmospheric conditions. Data are reported at a fixed nozzle-to-surface distance that corresponds to a monotonic decrease in heat transfer coefficient for single-phase jet impingement. A mini nozzle is used in the present study with an internal diameter of 1.16 mm. Experiments are performed at three sub-atmospheric pool pressures of 0.2 bar, 0.3 bar and 0.5 bar. At each pressure, jet impingement boiling at four Reynolds numbers are characterized and compared with the pool boiling heat transfer. Enhancements in critical heat flux with increasing Re are observed for all pressures.

Submerged jet impingement boiling has the potential to enhance pool boiling heat transfer rates. In most practical situations, the surface could consist of multiple heat sources that dissipate heat at different rates resulting in a surface heat flux that is non-uniform. This paper discusses the effect of submerged jet impingement on the wall temperature characteristics and heat transfer for a non-uniform heat flux. A mini-jet is caused to impinge on a polished silicon surface from a nozzle having an inner diameter of 1.16 mm. A 25.4 mm diameter thin-film circular serpentine heater, deposited on the bottom of the silicon wafer, is used to heat the surface. Deionized degassed water is used as the working fluid and the jet and pool are subcooled by 20°C. Voltage drop between sensors leads drawn from the serpentine heater are used to identify boiling events. Heater surface temperatures are determined using infrared thermography. High-speed movies of the boiling front are recorded and used to interpret the surface temperature contours. Local heat transfer coefficients indicate significant enhancement upto radial locations of 2.6 jet diameters for a Reynolds number of 2580 and upto 6 jet diameters for a Reynolds number of 5161.

No abstract

An experimental study of mini-jet impingement boiling is presented for saturated and subcooled conditions. Unique to this study is the documentation of boiling curves of submerged water jet impingement under sub-atmospheric conditions. Data are reported at a single sub-atmospheric pool pressure of 0.176 bar and for a fixed nozzle-to-surface distance of six jet diameters. A mini nozzle is used in the present study with an internal diameter of 1.16 mm. Jet impingement boiling at Reynolds numbers in the range of 0 to 6,800 are characterized and contrasted for both saturated and subcooled conditions. Enhancements in critical heat flux with increasing Re are observed for both saturated and subcooled conditions, with the subcooled condition of 17 °C showing approximately 2.3 times the critical heat flux as that observed for saturated conditions. Critical heat flux for subcooled jet impingement boiling is well predicted from the saturated critical heat flux data by a modified subcooled pool boiling CHF correlation presented by Inoue et al. [1]. The effect of surface finish on pool boiling is also reported.