Silver nanoparticles (AgNPs) are widely used in industry, consumer products, and medical appliances due to their efficient antimicrobial properties. However, information on environmental toxicity and bacterial impact of these particles is not completely elucidated. Results showed that AgNPs produced growth inhibition and oxidative stress in bacteria Escherichia coli (gram negative) and Staphylococcus aureus (gram positive), with half-maximal inhibitory concentrations (IC) of 12 and 7 mg/L, respectively. Surprisingly, bacteria pre-exposed to sublethal dose of AgNPs exhibited increased resistance toward antibiotics (ampicillin and Pen-Strep) with IC elevated by 3-13-fold. Further, AgNP pre-exposure raised the minimal inhibitory concentration and minimal biocidal concentration by two- to eightfold when cells were challenged with antibiotics with diverse mechanisms of action (penicillin, chloramphenicol, and kanamycin). Interestingly, we found that upon exposure to ampicillin, strains pretreated with AgNPs exhibited lower levels of membrane damage and oxidative stress, together with elevated levels of intracellular ATP relative to untreated cells. Bacterial reverse mutation assay (Ames test) showed that AgNPs are highly mutagenic, consistent with further assays demonstrating abiotic reactive oxygen species (ROS) generation and intrinsic DNA cleavage activity in vitro of AgNPs. Overall, our results suggest that AgNPs enhance bacterial resistance to antibiotics by promoting stress tolerance through induction of intracellular ROS. Our data suggest potential consequences of incidental environmental exposure of bacteria to AgNPs and indicate the need to regulate use and disposal of AgNPs in industry and consumer products.

Highly fluorescent N-substituted 1-cyanobenz[f]isoindole chitosans (CBI-CSs) with various degrees of N-substitution (DS) were synthesized by reacting chitosan (CS) with naphthalene-2,3-dicarboxaldehyde (NDA) in the presence of cyanide under mild acidic conditions. Introduction of 1-cyanobenz[f]isoindole moieties into the CS backbone resulted in lowering of polymer thermal stability and crystallinity. The fluorescence quantum yield (Φf) of CBI-CS was found to be DS- and molecular-weight-dependent, with Φf decreasing as DS and molecular weight were increased. At similar DS values, CBI-CS exhibited 26 times higher Φf in comparison with fluorescein isothiocyanate-substituted chitosan (FITC-CS). CBI-CS/TPP nanoparticles were fabricated using an ionotropic gelation method in which pentasodium triphosphate (TPP) acted as a cross-linking agent. CS and CBI-CS exhibited low cytotoxicity to normal skin fibroblast cells over a concentration range of 0.1-1000 μg/mL, while an increased cytotoxicity level was evident in CBI-CS/TPP nanoparticles at concentrations greater than 100 μg/mL. In contrast with CBI-CS polymers, the CBI-CS/TPP nanoparticles exhibited lower fluorescence; however, confocal microscopy results showed that living normal skin fibroblast cells became fluorescent on nanoparticle uptake. These results suggest that CBI-CS and fabricated nanoparticles thereof may be promising fluorescence probes for live cell imaging.

In this study, the chitosan and its derivatives were tested for their preservative activities for field natural rubber (NR) latex. A series of chitosans with different molecular weights were obtained by nitrous acid depolymerization. The chemically modified chitosans, Ncarboxymethyl chitosan (NCMCh), N-sulfated chitosan (NSCh), and N-(2-hydroxy)propyl-3-trimethylammonium chitosan chloride (NHTACh), were prepared from high and low-molecular weight chitosans. Preservative activities for field NR latex of these chitosans were investigated based on the measurement of volatile fatty acids (VFA) number of the treated latex. The preservative activities of chitosan increased with decreasing molecular weights. The lowmolecular weight NSCh and NHTACh exhibited good preservative activity for the latex. By the use of low-molecular weight NHTACh in combination with octylphenol poly (ethyleneglycolether) (Nonidet P40), the latex was successfully preserved for more than 1 month in the low-ammonia condition. The results showed an attractive feature to develop the preservative system, which was possible to reduce the concentrations of ammonia and carcinogenic nitrosamine in the NR latex.