In the present work, Zn-HA composites were developed by powder metallurgy route targeted for bone implant applicaitons. Zn-HA powders with varying HA content (1, 2, and 4 wt.%) were ball milled for 1 hr and sintered to produce composite compacts. X-ray diffraction (XRD) studies were done for all the ball milled powders and sintered compacts. No impurities were observed in the ball milled powders. Microstructural observations revealed the formation of lamellar structure in the composites due to the plastic deformation of the Zn powders during ball milling. Grain size measurements revealed the decreased grain size with increase of addition of HA. Furthermore, aspect ratio (length to thickness ratio) of the grains was measured and found that the aspect ratio was also decreased with the increased HA content. Higher microhardness was measured for all the composites compared with pure Zn. However, composite with 1% has shown higher hardness compared with the remaining composites. Form the preliminary observations, it can be concluded that Zn-HA composites can be successfully produced with lamellar morphology by ball milling followed by sintering for biomedical applications with increased hardness.

Pathology specimens are invaluable study adjuncts. While the storage and handling of these specimens may be cumbersome, their preservation in suspensions such as formalin for a longer period may result in objectionable odour, discolouration and irritation. These disadvantages can be overcome by an alternate technique called as “Plastination”. This technique is fast emerging as a method for conservation of pathological specimens. This review lays emphasis on the process, technique and potential uses of plastination in conservation of pathological specimens.