The current–voltage characteristics of methanofullerene [6,6]‐phenyl C61‐butyric acid methyl ester (PCBM)‐based devices are investigated as a function of temperature. The occurrence of space–charge limited current enables a direct determination of the electron mobility. At room temperature, an electron mobility of μe = 2 × 10–7 m2 V–1 s–1 has been obtained. This electron mobility is more than three orders of magnitude larger than the hole mobility of donor‐type conjugated polymer poly(2‐methoxy‐5‐(3′,7′‐dimethyloctyloxy)‐p‐phenylene vinylene) (OC1C10‐PPV). As a result, the dark current in PCBM/OC1C10‐PPV based devices is completely dominated by electrons. The observed field and temperature‐dependence of the electron mobility of PCBM can be described with a Gaussian disorder model. This provides information about the energetic disorder and average transport‐site separation in PCBM.

The dependence of the performance of OC1C10‐PPV:PCBM (poly(2‐methoxy‐5‐(3′,7′‐dimethyloctyloxy)‐p‐phenylene vinylene):methanofullerene [6,6]‐phenyl C61‐butyric acid methyl ester)‐based bulk heterojunction solar cells on their composition has been investigated. With regard to charge transport, we demonstrate that the electron mobility gradually increases on increasing the PCBM weight ratio, up to 80 wt.‐%, and subsequently saturates to its bulk value. Surprisingly, the hole mobility in the PPV phase shows an identical behavior and saturates beyond 67 wt.‐% PCBM, a value which is more than two orders of magnitude higher than that of the pure polymer. The experimental electron and hole mobilities were used to study the photocurrent generation of OC1C10‐PPV:PCBM bulk‐heterojunction (BHJ) solar cells. From numerical calculations, it is shown that for PCBM concentrations exceeding 80 wt.‐% reduced light absorption is responsible for the loss of device performance. From 80 to 67 wt.‐%, the decrease in power conversion efficiency is mainly due to a decreased separation efficiency of bound electron–hole (e–h) pairs. Below 67 wt.‐%, the performance loss is governed by a combination of a reduced generation rate of e–h pairs and a strong decrease in hole transport.

A solution‐processed polymer tandem cell fabricated by stacking two single cells in series is demonstrated. The two bulk‐heterojunction subcells have complementary absorption maxima at λmax ∼ 850 nm and λmax ∼ 550 nm, respectively. A composite middle electrode is applied that serves both as a charge‐recombination center and as a protecting layer for the first cell during spin‐coating of the second cell. The subcells are electronically coupled in series, which leads to a high open‐circuit voltage of 1.4 V, equal to the sum of each subcell. The layer thickness of the first (bottom) cell is tuned to maximize the optical absorption of the second (top) cell. The performance of the tandem cell is presently limited by the relatively low photocurrent generation in the small‐bandgap polymer of the top cell. The combination of our tandem architecture with more efficient small‐bandgap materials will enable the realization of highly efficient organic solar cells in the near future.

To date there are two demonstrated technologies for the fabrication of organic integrated circuits: the unipolar and the complementary technology. Unipolar architectures consist of p-channel organic field-effect transistors (OFETs), which are simple to fabricate since they require a single, high-workfunction metal (e.g., gold) and a single semiconductor material, which can be either evaporated or solution-processed.

No abstract