The structure of the Nafion ionomer used in proton-exchange membranes of H(2)/O(2) fuel cells has long been contentious. Using a recently introduced algorithm, we have quantitatively simulated previously published small-angle scattering data of hydrated Nafion. The characteristic 'ionomer peak' arises from long parallel but otherwise randomly packed water channels surrounded by partially hydrophilic side branches, forming inverted-micelle cylinders. At 20 vol% water, the water channels have diameters of between 1.8 and 3.5 nm, with an average of 2.4 nm. Nafion crystallites (approximately 10 vol%), which form physical crosslinks that are crucial for the mechanical properties of Nafion films, are elongated and parallel to the water channels, with cross-sections of approximately (5 nm)(2). Simulations for various other models of Nafion, including Gierke's cluster and the polymer-bundle model, do not match the scattering data. The new model can explain important features of Nafion, including fast diffusion of water and protons through Nafion and its persistence at low temperatures.

The present work describes the fabrication, characterization, and optimization of NH 2derivatized polymer coatings prepared by pulsed-plasma polymerization for applications as adhesion layers in DNA immobilization. Fourier transform infrared spectroscopy and surface plasmon resonance spectroscopy were used to study (i) polymer matrix properties and (ii) oligonucleotide/DNA binding. The successful DNA attachment on amine functionalized surfaces was found to depend on the macromolecular architecture of the plasma films and on the amine group densities. Pulsed and continuous wave plasma polymers deposited at similar equivalent power showed comparable immobilization properties, while low duty cycle plasma-polymerized films showed a higher sensitivity toward DNA binding than high duty cycle plasma-deposited films. The stabilities of the various films in buffer solution and their reactivities as they were affected by variations in pH have been investigated.

Orthopedic and dental implants are increasingly used in the medical field in view of their high success rates. Implant-associated infections, however, still occur and are difficult to treat. To combat these infections, the application of an active coating to the implant surface is advocated as an effective strategy to facilitate sustained release of antibacterial drugs from implant surfaces. Control over this release is, however, still a major challenge. To overcome this problem, we deposited composite coatings composed of a chitosan matrix containing gelatin nanospheres loaded with antibiotics onto stainless steel plates by means of the electrophoretic deposition technique. The gelatin nanospheres were distributed homogeneously throughout the coatings. The surface roughness and wettability of the coatings could be tuned by a simple adjustment of the weight ratio between the gelatin nanospheres and chitosan. Vancomycin and moxifloxacin were released in sustained and burst-type manners, respectively, while the coatings were highly cytocompatible. The antibacterial efficacy of the coatings containing different amounts of antibiotics was tested using a zone of inhibition test against Staphylococcus aureus, which showed that the coatings containing moxifloxacin exhibited an obvious inhibition zone. The coatings containing a high amount of vancomycin were able to kill bacteria in direct contact with the implant surface. These results suggest that the antibacterial capacity of metallic implants can be tuned by orthogonal control over the release of (multiple) antibiotics from electrophoretically deposited composite coatings, which offers a new strategy to prevent orthopedic implant-associated infections.