I-V characterization of Ta-Ta2O5-MnO2 capacitors was investigated at different temperatures, and Poole–Frenkel (PF) emission saturation was experimentally observed. Under the saturation voltage, the I-V curves at different temperature converged, and the temperature dependency was vanished. Above the saturation voltage, the leakage current was decreasing as the temperature increased. In order to evaluate the effects of saturation voltages (VS) on time-to-failure (TTF) of the capacitors, VS were first determined at +2°C and +25°C, then voltage accelerating tests were conducted at 85°C under 1.6 times of rated voltage. The distribution of VS and TTF of the samples were plotted and compared. It was shown that samples with lower saturation voltage failed earlier in the distribution of time-dependent dielectric breakdown. Comparing conventional methods for evaluating the quality of tantalum capacitors by measuring the leakage current at elevated temperature, the nondestructive measurement of saturation voltage at +2°C and +25°C may provide a novel and practicing approach tool to screening out capacitors with defected Ta2O5 layers.

The leakage currents of high nominal voltage conductive polymer tantalum (Ta) electrolytic capacitors are the difficulties in the research and development processing. The optimized and improved forming technical of increasing current density with the voltage rising was used in the present paper, and silane coupling agent has been used to the dielectric surface of the electrode body before polymerization, and conductive slurry was used to forming the cathode electrolyte of capacitors. Low leakage currents and high breakdown voltage have been tested; otherwise, the endurance capabilities of reverse voltage have prodigious enhanced.

Due to the importance of capacitance temperature stability in precise analog circuit applications, capacitance instability at elevated temperature of 125 ∘ C was investigated in tantalum capacitors with PEDOT:PSS counter electrodes. Capacitance-voltage measurement supposed that residual ions in the PEDOT:PSS dispersion caused an accumulation of charges at the dielectric-cathode interface which contributed to an increase in the dielectric constant and resulted in the capacitance increasing at high temperature. Based on the hypothesis, water wash process was applied and capacitance dropped significantly at high temperature. This study shows that an additional water wash process is necessary to improve the capacitance temperature stability after each dispersion dip step.