The influence of four different vaneless diffuser shapes on the performance of centrifugal compressors is numerically studied in this paper. One of the studied shapes was a parallel wall diffuser. Two others had the width reduced only from hub and shroud and the rest had the width reduced from hub and shroud divided evenly. Then the numerical simulation was employed and the overall compressor aerodynamic performance was studied. The detailed velocity and pressure distribution and energy loss within the centrifugal compressor with different diffuser geometries and different operating conditions were analyzed. The results revealed that shroud pinch significantly improved the overall compressor aerodynamic performance more than any other pinch types, and the best performance can be achieved by pinched diffusers under the design condition compared with pinched diffusers under the near surge condition or choking condition. The range of energy loss, namely the static entropy area in the compressor, become reduced with the above three pinches diffusers.

Two types of stall patterns in the centrifugal compressor with a wide vaneless diffuser were numerically studied in this paper. We carried out kinds of three-dimensional numerical simulations of the instability process in wide vaneless diffusers with different radius ratios. The results show that there are two kinds of stall patterns in wide vaneless diffusers with different radius ratios. For a short diffuser with a radius ratio of 1.5, the speed of the propagation of stalled cells is relatively high, and the propagation speed and frequency of stall cells do not change with the decrease in the flow rate. For a long diffuser with a radius ratio of 1.8, the propagation velocity of stall cells is smaller to the one in the short diffuser, and increases with the decrease in flow rate. For wide vaneless diffusers with different radius ratios, the main factor causing stall is the outlet reflux. Reducing the radius ratio of the wide vaneless diffuser has an important influence on the stability of the centrifugal compressor.